Filter
Top Products
9
PXSE
SLEEVE EXTENSION RETROFIT KIT G-90 zinc
coated steel, 2¼" sleeve extension attached to the
room side of the sleeve to allow for the installation
of a P-Series Friedrich PTAC in a T-Series sleeve.
PXDA
LATERAL DUCT EXTENSION A three foot
insulated plenum that attaches to the left or right
side of the duct adapter. The extension can be cut
to length by the installer. Maximum allowable
straight extension is fifteen feet.
PXDE
PXFT
SEACOAST PROTECTION Additional protection for PTAC/PTHP units in a coastal or
corrosive environment. The entire outdoor coil is submerged in a specially formulated
enamel coating, then oven-cured for a tough, corrosion-resistant finish.
CC
CC
C
STANDARD UNIT Standard PTAC/PCHP chassis. Can be 230/208V or 265V, electric
or heat pump.
REMOTE THERMOSTAT Chassis option necessary for wall mounted thermostat
control of the unit.
REPLACEMENT FILTER PACK These are original
equipment return air filters. They are reusable and
can be cleaned by vacuuming, washing, or blowing
out, and are sold in convenient ten packs. (Two
filters per chassis).
LATERAL DUCT ADAPTER Attaches to the PTAC/
PTHP unit and provides a transition to direct up to
35% of the total CFM to a secondary room, either
left or right of the unit. Kit includes duct plenum
with discharge grille and internal baffle, adapter and
end cap.
SS
SS
S
RR
RR
R
MODEL NUMBER DESCRIPTION PHOTO
DESK CONTROL KIT A field installed kit which
allows the unit to be turned on or off from a remote
central station via a 24V interface. This kit is
compatable with all chassis models.
PXDC
RT1
DIGITAL REMOTE THERMOSTAT A Honeywell
wall mounted remote thermostat. Compatable only
with "RT" suffix chassis.
New Construction Accessories (Continued)
Additional Accessories
MODEL NUMBER DESCRIPTION PHOTO
DESCRIPTIONITEM
Chassis Options
PXDC
RT1
PXSE
PXDA
PXFT