Filter
Top Products
8
New Construction Accessories
Friedrich PTAC Accessories
MODEL NUMBER DESCRIPTION PHOTO
WALL SLEEVE G-90 zinc coated steel is prepared
in an eleven-step process, then powder coated for
maximum coverage and protection. The wall
sleeve is insulated for thermal efficiency. 16" High
x 42" Wide x 13¾" Deep.
PXWS
DEEP WALL SLEEVE EXTENSION A four inch
deep anodized aluminum extension that attaches
to the outside of the wall sleeve when
the wall is
greater than thirteen inches thick (11¾
" when a
subbase is used, 12¼" when a lateral duct is used).
PXWE
GRILLE Standard, stamped aluminum, anodized
to resist chalking and oxidation.
PXAA
PXDB
PXSC
ARCHITECTURAL GRILLES Consist of heavy-
gauge 6063-T5 aluminum alloy:
– Clear, extruded aluminum
– Dark bronze acrylic enamel
– Also available in custom colors.
PXDR10
CONDENSATE DRAIN KIT Attaches to the bottom
of the wall sleeve for internal draining of condensate
or to the rear wall sleeve flange for external draining.
Recommended on all units to remove excess
condensate. Packaged in quantities of ten.
PXSB
DECORATIVE SUBBASE Provides unit support
for walls less than six inches thick. Includes leveling
legs, side filler panels and mounting brackets for
electrical accessories. Accepts circuit breaker,
power disconnect switch, or conduit kit.
PXCJ
CONDUIT KIT WITH JUNCTION BOX Hard wire
conduit kit with junction box for 208/230V and 256V
units (subbase not required). Kit includes a means
of quick disconnect for easy removal of the chassis.
*Required for 265V installations.
PXWS
PXDB
PXDR10
PXWE
PXSB
PXCJ
PXGA