Everpure HTS-11 Water System User Manual


 
B E N E F I T S
A P PL I C A T I ON /S I Z I N G
I N S T A L L A T I ON T I P S
OP E R A T I ON T I P S
K le e n wa r e H T S- 1 1 S y st e m
Scale prevention and corrosion control for warewashing equipment
Kleenware HTS-10 System: EV9799-10
Scale control system features HydroBlend which
inhibits mineral deposits and provides corrosion
protection
Extends the life of expensive foodservice
equipment
Opaque (red) high temperature bowl
allows for hot water (up to 200°F) feed
installations
Transparent replacement cartridge containing
HydroBlend scale inhibitor, which is effective
up to 200°F
Specially designed flow through head assures
consistent, predictable product feed rates
The HTS-11 system must be used as a unit (i.e.
high temperature bowl, head and cartridge)
Install vertically using the mounting bracket
provided
Use 3/4” water line and observe proper
inlet/outlet water directions
Some pressure relief mechanism should be
provided downstream of the system to permit
releasing line pressure when changing cartridges
Deliming of equipment prior to installation is
recommended, but not required
Inspect HT-10 cartridge at least every 6 months
for replacement
Pre-existing equipment scale may be dislodged
and settle to the bottom of a chamber which can
clog drain initially. Remove any settled scale
In new installations, the HydroBlend usage rate
may start high, but will be reduced as existing
scale is removed
Replace HT-10 cartridge before HydroBlend™
compound is completely used up
Commercial dishwashers
Commercial glassware washers
Warewashing booster heaters
EV9799-11
HT-10 Replacement Cartridge: EV9799-22
Kleenware HTS-11 System: EV9799-1
1