Filter
Top Products
BENEFITS
APPLICATION/SIZING
INSTALLATION TIPS
OPERATION TIPS
WS-Series
Water Conditioning for Commercial and Light Industrial
Applications Available in Single Tank System with 1" Porting
WS-30: EV9980-10
WS-30: EV9980-10
Hardness removal of 30,000 to 45,000grains at
flow rates up to 12 gallons per minute continuous
Meter initiated regeneration minimizes salt, water
and electrical costs
Advanced user-friendly controls incorporates
time-tested hydraulically balanced piston, seal
and spacer design to pilot service flow and
regeneration
Large capacity brine tank maximizes time
between refills
Fiberglass reinforced resin vessels with NSF
approved polyethylene liners eliminate worries
about corrosion
Single tank design for simplicity, economy and
space savings
5-cycle control delivers controlled upflow
backwash, downflow brining and slow rinse, rapid
rinse, timed brine refill and downflow service
Locate equipment on a smooth, level surface
Maintain an air-gap at the end of the drain line
Secure drain line directly over floor drain or stand
pipe
When connecting a water heater, install a check
valve on the soft water piping to prevent hot
water back-up
When sweating/installing copper piping, protect
the control valve from excessive heat
Check local codes for additional equipment that
may be required, such as backflow prevention
devices (I.e., RPZ)
Check for softened water each time salt is added,
by using soap of hardness test kit
Use a good quality grade of salt - Solar or pellet
are preferred
Check the salt level on a regular basis
Maintain a minimum Salt depth of 6" to ensure a
proper regeneration
On iron bearing waters, use a salt that contains an
iron "fighting" additive, or use a resin cleaner on
a regular basis
Check the water level in the brine tank. If
abnormally high - refer to IO guide for
troubleshooting information
Reverse Osmosis Pre-treatment
Espresso Machines
Warewashing
Laundry-Linen & Uniform
Boiler Scale Control
Water Heater Scale Protection/Reduction
General Housekeeping
EV9980-10