England's Stove Works 10-CDV Stove User Manual


 
9
BURNING SOLID FUELS
Ashes will need to be removed from the unit periodically. See Ash Removal section. You can
minimize cleaning required and maximize efficiency by maintaining the proper draft.
This unit has been designed to burn dry shelled corn or premium hardwood pellets that meet the
association of pellet fuel industry standards.
Shelled corn (dry, preferably corn with 11-12% moisture content)
Never burn “deer corn” as it frequently contains molasses/sugars.
Store your corn supply in a dry place and keep bags or container sealed to prevent your corn from
absorbing excess moisture. Test the moisture content regularly to ensure proper dryness.
IMPORTANT: DO NOT BURN “TREATED” SEED CORN IN YOUR STOVE. Seed corn is treated
with chemical pesticides that are harmful or fatal if swallowed
; therefore, seed corn is
dangerous to have in the house, especially where children can reach it. Burning
treated seed corn in your stove will void your warranty and will destroy the
exhaust system on the unit.
WOOD PELLETS
As with corn, be consistent in your choice of wood pellet supplier. Pellets will vary in content and
burn characteristics from supplier to supplier.
Check your pellets for foreign objects. Your stove warranty will not cover any damage caused
due to foreign objects in the fuel supply.
Store your pellets in a dry place to prevent them from absorbing added moisture.
To decrease sawdust buildup, the hopper will need to be vacuumed out after every 6-8 bags of
pellets, or more often if the quality of the pellets are poor. You may need to screen each bag of
pellets if the sawdust becomes a problem.
Wood pellets vary in size and also ash content (from less than 1% to 3% or more). Your unit will
burn more efficiently with small to mid-size pellets. Low ash content pellets will allow you to burn
the stove longer between cleanings.
Your unit is designed to burn pellets that are no larger than one-quarter inch (¼”) in diameter,
and no longer than two and one-half inches (2 ½”) long.
CAUTION: DO NOT PLACE SUCH FUELS WITHIN THE SPACE HEATER’S INSTALLATION
CLEARANCES OR WITHIN THE SPACE REQUIRED FOR CHARGING AND ASH REMOVAL.
SETTING THE STIRRER
Warning: Do not open the door on this unit if the stirrer is still moving!
Bodily Injury can occur!
The stirrer may be turned Off by pushing the “Air On” button on the bottom of the Control
Panel, and then pressing the Down
arrow on the “Blower Speed” until you see a “0” in the
Blower Speed window.
The stirrer may be turned back On by pressing the “Air On” button on the bottom of the
Control Panel, and then pressing the Up
arrow on the “Blower Speed” until you see a “1” in
the Blower Speed window.