England's Stove Works 10-CDV Stove User Manual


 
22
ACCESSORY ITEMS
The following accessories can be added to your unit at anytime after purchase; however, let the
unit cool down before adding any accessories.
Thermostat
WALL: An external wall thermostat (such as our Part # GU-1E30-914) can be used on our
corn/pellet units as long as it is a low-voltage that works with millivolt systems. After unplugging the
unit, locate the jumper wire (J-3) on the bottom of the control panel. The two screws should then be
loosened and the jumper wire removed from the board. Next, the two thermostat lead wires should
be slipped into these openings and the screws tightened; the jumper wire should be saved for future
operation without a thermostat.
The unit will operate differently once the wall thermostat is connected – we recommend the
Control Board be set at “9” on Heat Range and Blower Speed while using the thermostat. Refer to
the section on “Start-up Procedure” for information on cold starts.
AC-117, AC-117BN Lip Trim
There are two pieces of J-Channel trim in this kit that snap onto the ash apron and top lips of the
stove. Match the channel with the correct edge of the lip, then remove the protective covering from
the trim and force the piece onto the edge. Although it should stay in place, stove cement can be
used to secure it if necessary.
AC-118, AC-118BN Window Trim
Window trim can be attached by using the provided spring clip(s) and some high temperature
silicone (optional). Insert the tee end of the spring clip into the channel on the edge of the trim – then,
turn the clip and set the other end of the clip into the channel. The spring clip will hold well if it is
placed on the top edge of the trim before placing the trim in the window of the stove. Place the top
edge with the clip into the window opening, then push the bottom edge of the trim flush with the
window. We also suggest that high temperature silicone be used on the corners, to ensure the trim
will stay in place.
Accessories can be ordered from the factory at:
(Parts orders ONLY) -- (800) 516-3636, or on our web site:
www.englanderstoves.com .
Questions/Problems: Please call Customer Service at (800) 245-6489.