Empire Comfort Systems SE-300 Stove User Manual


 
SECTIONAL PARTS FOR GAS STOVE
SP-010 One-Burner Top SP-013 One-Burner Drip Pan SP-028 Burner hanger
SP-011 Two-Burner Top SP-014 Two-Burner Drip Pan R-3339 Grate
SP-012 Three-Burner Top SP-015 Three-Burner Drip Pan SP-055 Round Burner
SP-076 One-Burner Semi-Enclosed Frame* P-220 One-Hole Manifold SP-062 Star Burner
SP-064 Two-Burner Semi-Enclosed Frame P-219 Two Hole Manifold SP-016 6" Low Leg
SP-063 Three Burner Semi-Enclosed Frame P-221 Three Hole Manifold S-1377 28" High Leg
SP-065 One-Burner Mini-Stove Frame SP-034 Manifold Clamp S-1380 32" High Leg
SP-066 Two-Burner Mini-Stove Frame R-3337 Knob S-1388 Leg Brace for 32" High
SP-067 Three-Burner Mini-Stove Frame R-3445 Gas Valve SW2-1 Two-Burner Windscreen
* Not Shown SW3-1 Three-Burner Windscreen
CAUTION: Orifice HOODS must again be turned down, if the gas
stove is to be used on LP gas after it has once been adjusted for other
gases.
UNDER NO CIRCUMSTANCES SHOULD ANYALTERATIONS
BE MADE TO THE GAS VALVE AND BURNER ASSEMBLY.
Warranty
Empire Comfort Systems, Inc. makes no claim of fitness of this prod-
uct for a particular purpose or use and assumes no liability for damages
resulting from the use of the product. Liability of the manufacturer in
any event is limited to the amount of the original purchase price of this
product. This warranty applies only to the use of the product in
accordance with the manufacturer's operating instructions, and remains
in force only so long as the product remains in its original
configuration. This warranty does not apply to products that have been
altered or repaired by outside agents, abused, damaged through neglect,
misuse, or accident, or to products that have been used in any way other
than in accordance with manufacturer's operating instructions. There
are no other warranties, expressed or implied, pertaining to this product
or any other product sold by us. Empire Comfort Systems, Inc. neither
assumes any responsibility in its behalf for operation of this or any
other product manufactured or sold.
W
ARNING: NEVER PUT HANDS OR
FACE
DIRECTLY OVER BURNER WHILE
LIGHTING
You may adjust valve setting at this time.
The flame should show a greenish
blue inner cone with a slight yellow
tip. If necessary, you can make an
adjustment by turning the hood of the
valve in a counterclockwise direction
until the flame performance is
satisfactory. See other side for further in-
structions regarding valve setting.
DO not
tamper with or attempt repairs on the burners, frames valves, or
LP cylinder. Allow only qualified LP Gas Dealers to make repairs and
adjustments.
Always close
LP cylinder valve after use. Always use and store bottle in
an upright position. Never store or transport these cylinders in an
occupied enclosure.
Adjustment Instructions-Universal Gas Valve
Your portable gas stove is furnished with A.G.A. listed Universal type
Gas Valve. This valve is designed for use with (Liquefied Petroleum
LPG), Natural or Manufactured Gas. When gas plate is installed the
valve should be set for the kind of gas to be used.
The universal valve is adjusted for the various gases by turning the
ADJUSTING HOOD. To turn HOOD use wrench on HOOD SHOUL-
DER. This may be done after gas stove is assembled as HOOD
SHOULDER is easily accessible.
1. This valve is shipped from the factory adjusted for LP gas. If LP gas
is to be used, no adjustments should be necessary. Orifice HOOD
can be open slightly to get desired flame.
2. For use with Natural or Manufactured gas open HOOD until the
proper amount of gas is fed to each burner. When properly adjusted
the flame should have greenish blue inner cones about one-half inch
long. An unnecessary high flame is wasteful and inefficient.
3. The air shutter for each burner should be adjusted so the flame burns
clean without blowing. After you obtain the correct setting or the air
shutter, lock in place by tightening the air shutter screw.
CAUTION: MAXIMUM WORKING PRESSURE 1/2 P.S.I. 11-INCH WATER COLUMN
(LOW PRESSURE REGULATOR IS REQUIRED)
ADJUSTING PIN
HOLE IN
ADJUSTING PIN
ADJUSTING HOOD
ADJUSTING HOOD
SHOULDER
VALVE BODY
GAS ENTRANCE
DUST COVER
STEM
S-1111
S-1266
S-1188
S-1277 S-1288 S-1299 S-1300 S-1311
S-1366 S-1377 S-1380 S-1389
S-1322 S-1333
SW2-1 SW3-1 S-1211 S-1222 S-1233 S-1244 S-1255
S-1122 S-1133 S-1144 S-1155 S-1166 S-1177
R-3088Page 2
LEG
BURNER
AIR
SHUTTER
KNOB
DRIP
PAN
MANIFOLD
CLAMP
GAS
VALVE
MANIFOLD
STOVE
GRATE
SP-010 SP-011 SP-012 SP-064 SP-063 SP-065 SP-066
SP-067
P-221
SP-034
R-3337
R-3445
SP-016
SP-028 R-3339 SP-055
SP-062
SP-013 SP-014 SP-015 P-220 P-219