Filter
Top Products
11
INSTALLATION
Installation
Thermostat
1) Pull the thermostat o the base using tabs shown above.
2) Place base over wire hole in wall and mark mounting hole locations using
base as a template. Drill mounting holes.
3) Fasten base snugly to wall using wall anchors and two mounting screws.
Leveling is for appearance only and will not aect thermostat operation.
4) Connect wires to terminal block on base.
IMPORTANT: Wiring from equipment control should correspond with
wiring to thermostat. (see Fig. 8)
5) Carefully line the thermostat up with the base and snap into place.
Tabs