Ei Electronics Ei 164R Heat Smoke Alarm User Manual


 
Model Ei 164R Heat
Remote control capability
Easi-Fit base
Tamper proof rechargeable lithium battery back up
Fixed temperature fast response thermistor type
sensor, range 54C to 62C
Test/Hush button
Advanced suppression and calibration technology
Interconnectable to other Ei mains powered alarms
Low power cell warning
Kitemarked to BS5446-2:2003
5 year guarantee
Product Description
The Ei164R is a Heat Alarm that runs on 230V AC mains
power, and has built in tamper proof rechargeable lithium
cells that act as a battery back up in the event of mains
failure. These rechargeable lithium cells are designed to
have a ten year life and outlast the life of the heat alarm
itself, whilst providing up to six months of heat alarm
operation without mains power.
The Ei164R is supplied with the Easi-Fit base that allows
very quick and simple installation of the heat alarm,
combined with simple detector head removal and
replacement. The Easi-Fit base automatically connects
both mains power and battery as the detector head
slides on to the Easi-Fit base.
The Ei164R allows the detector to be controlled remotely
by either a “Test/Hush” Switch (Ei152) or a Manual Call
Point (MCP400). If the Ei164R is also interconnected to
other Ei mains powered alarms then the whole system
will be controllable remotely.
The Ei164R has built in circuitry to aid suppression of
voltage transients and RF interference to further reduce
the chances of false alarms under such conditions.
Heat alarms are ideal for use in kitchens and garages,
where the use of optical or ionisation alarms would lead
to unwanted nuisance alarms.
Operation
The green indicator will illuminate to show mains
power is present
The red indicator will flash every 40 seconds to
show that the detector has performed an automatic
self test
The red indicator will flash rapidly to show an alarm
condition for the heat detector
The “Test/Hush” button will either silence false
alarms or perform a unit self test
In “Test” mode the alarm will perform a self test and
sound the horn
In “Hush” mode the alarm enters a ten minute period
of reduced sensitivity to overcome false alarm
conditions, and will then automatically reset itself
When interconnected to other Ei mains powered
alarms, an alarm on one detector will trigger all other
interconnected alarms within one second (only the
triggered alarm will flash a red indicator)
The heat detector will emit a beep every 40 seconds
to indicate that the battery back up is depleted and
needs recharging
MAINS POWERED 230V~
Rechargeable Battery Back-Up
Shannon Free Zone, Shannon, Co. Clare, Ireland.
Ph.+353 61 471277 Fx.+353 61 471053
Email. eielectronics@eiltd.ie
www.eielectronics.com