Filter
Top Products
Copyright 2000, 2002 Dri
-
Eaz Products, Inc. 4
SPECIFICATIONS
Model DRIZAIR 80 and 80 DX DRIZAIR 1200 DRIZAIR 2000 LG DRIZAIR 2400 LG
Water Removal,
maximum
80 pints
(10 gallons)
38 liters 123 pints
(15 gall.)
58 liters 198 pints
(25 gallons)
94 liters 240 pints
(30 gallons)
114 liters
Water Removal,
AHAM
40 pints
(5 gallons)
19 liters 64 pints
(8 gallons)
30 liters 110 pints
(14 gall)
52 liters 148 pints
(18.5 gall.)
70 liters
Airflow 200 cfm 360 cmh 225 cfm 385 cmh 365 cfm 700 cmh 365 cfm 600 cmh
Use Weight 62 lb (76 DX) 31 kg (39 DX) 80 lbs 36 kg 132 lbs 60 kg 160 lbs 73 kg
Dimensions 21x14x16 in
34x19x20 (DX)
53x36x41 cm
86x48x51 (DX)
32x20x20
in
83x50x50
cm
41x24x23
in
103x61x57
cm
47x24x27
in
120x61x6
9 cm
Operating range 55° - 95° F 13° - 35° C 33° - 100° F 0° - 38° C 33° - 100° F 0° - 38° C 33° - 100° F 0° - 38° C
Safety Listings UL, C-UL UL, C-UL UL, C-UL UL, C-UL
Filter Foam Foam or Paper Foam or Paper Foam or Paper
Defrost Thermostat – Fan Defrost Hot Gas Bypass Hot Gas Bypass Hot Gas Bypass
Pump Centrifugal (DX only) Centrifugal Centrifugal Centrifugal
Refrigerant R-134A R-22 R-22 R-22
Compressor 3,926 BTU Reciprocating 6,670 BTU Rotary 10,120 BTU Rotary 13,315 BTU Rotary
One dehumidifier will dry the air in APPROXIMATELY the size of the following drying chamber or room(s) with a standard ceiling.
Soaking wet 200 sq ft 20 sq meters 350 sq ft 30 sq m 550 sq ft 50 sq m 750 sq ft 70 sq m
Moderately wet 300 sq ft 30 sq meters 500 sq ft 45 sq m 825 sq ft 75 sq m 1,100 sq ft 100 sq m
Mostly dry 600 sq ft 60 sq meters 1,000 sq ft 90 sq m 1650 sq ft 150 sq m 2,200 sq ft 200 sq m
Specifications are subject to change without notice. Some values are approximate.
TROUBLESHOOTING
In COLUMN 3, "FS" or Field Solutions can be handled by the technician in the field. Others solutions should be handled by a repair technician –
an "AST" or Authorized Service Technician.
WARNING: All the service procedures below should be executed with the power turned off, i.e. unplugged.
PROBLEM CAUSE
See
above SOLUTION
Unit does not operate No power to machine FS Plug in the unit; check power at outlet
Switch not turned on FS Turn on the switch
Compressor will not start Unit needs 5 minutes before re-start FS Switch off unit, wait 5 minutes before starting
Overload preventing start up FS Reduce room temperature below 100° F (38° C)
Faulty or broken wire AST Replace or repair broken/loose wire
Defective relay AST Check relay with volt/amp meter
Compressor not running AST Contact distributor or Dri-Eaz Products
Blower wheel not turning Obstructed blower FS Remove obstruction
Loose blower wheel set screw FS Tighten set screw
Loose or broken wire AST Replace broken wire
Burned out fan motor AST Replace fan motor
Dehumidifier operating Not enough time to dry FS Allow more time for drying
but room not dry Poor air movement FS Increase air movement with TurboDryers
Excessive air infiltration FS Reduce airflow into the area being dried
Only partial frost Possible leak in system AST Check for leak with gas leak detector
or moisture on coils Low charge in system AST Repair and recharge system
No moisture Possible leak in system AST Check for leak with gas leak detector
or frost on coils Capillary tubing damaged AST Look for damage, replace tubing
Compressor not running AST Contact distributor or Dri-Eaz Products
Unit continuously in defrost Room temperature too low FS Increase room temperature
Defective control assembly AST Replace control assembly
Defective bypass relay valve AST Replace bypass valve
Unit does not defrost Defective sensor AST Replace sensor
(heavy frost or ice Defective control assembly AST Replace control assembly
persists over several hours) Defective bypass relay valve AST Replace bypass valve
Unit collects little water Room air too dry FS Check humidity with a hygrometer
Room temperature too low FS Increase the room temperature
Airflow through unit restricted FS Increase airflow; clean filter and coils
Pump does not function Stuck float valve FS Clean float valve shaft
FOR PARTS AND SERVICE CALL YOUR LOCAL DISTRIBUTOR,
or the Dri-Eaz Service Department at (360) 757-7776