Dimplex R8/55 - 8kW Heating System User Manual


  Open as PDF
of 4
 
WARM AIR HEATING SYSTEM
Models: R7/47 - 7kW, R8/55 - 8kW, R10/73 - 10kW,
R12/84 - 12kW, R15/104 - 15kW
USER INSTRUCTIONS
IMPORTANT
PLEASE READ THIS LEAFLET CAREFULLY AND
RETAIN FOR FURTHER USE. NOTE ALSO THE
INFORMATION GIVEN ON THE HEATER
ELECTRICELECTRIC
ELECTRICELECTRIC
ELECTRIC
AIREAIRE
AIREAIRE
AIRE
• WARNING - THE SURFACES ON THIS HEATER CAN BE HOT.
• This heater meets BS 3456 safety requirements. However, any heater type becomes hot in normal operation. Care
must be taken to ensure that prolonged skin contact with the heater does not occur.
WHERE YOUNG CHILDREN, INFIRM PERSONS, OR THE AGED ARE LIKELY TO BE LEFT UNSUPERVISED IN
THE VICINITY OF THE HEATER WE RECOMMEND THAT A GUARD IS FITTED. Contact your installer or the
manufacturer for further advice.
• THIS APPLIANCE IS EXTREMELY HEAVY. THE FLOOR MUST BE CHECKED TO ENSURE THAT IT IS CAPABLE
OF BEARING THE WEIGHT OF THE UNIT, UP TO 750KG (¾ TON). DO NOT UNDER ANY CIRCUMSTANCES
ATTEMPT TO MOVE OR REPOSITION THIS HEATER WITHOUT SEEKING EXPERT ADVICE.
• To maintain stability, it is essential that the heater is placed on a level surface.
• The heater must be installed where it is possible for switches and other controls to be touched by a person in a
bath or shower.
• IMPORTANT - Due to the newness of materials the heater will produce a slight smell for the first few days of operation.
ROOMS MUST BE WELL VENTILATED AND YOUNG CHILDREN, CAGED BIRDS, OR PERSONS WITH
RESPIRATORY COMPLAINTS MUST NOT REMAIN IN CLOSE PROXIMITY TO THE HEATER DURING THE FIRST
48 HOURS OF THE COMMISSIONING PERIOD.
• IF, DURING ANY REASSEMBLY OF THE HEATER, A PART OF THE THERMAL INSULATION SHOWS DAMAGE
OR DETERIORATION WHICH MAY IMPAIR SAFETY, IT SHOULD BE REPLACED BY AN IDENTICAL PART.
• The heater must stand at least 50mm clear of any walls and 150mm below ceilings.
next