Desa CGD3018PT/NT Electric Heater User Manual


 
www.desatech.com 111160-01C
16
INSTALLING LOGS
CAUTION: After installation
and periodically thereafter,
check to ensure that no flame
comes in contact with any log.
With the heater set to HI, check
to see if flames contact any log.
If so, reposition logs according
to the log installation instruc-
tions in this manual. Flames
contacting logs will create soot.
WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only
parts specifically approved with
this heater may result in property
damage or personal injury.
Dual Burner Smoky Mountain Oak
Models CGD3018PT/NT, CGD3924PT/NT
Each log is marked with a number. These num-
bers will help you identify the log when install-
ing. It is very important to install these logs ex-
actly as instructed. Do not modify logs. Only use
logs supplied with heater.
1. Locate pins on the bottom of back log (#1).
Slide these pins into the holes in the grate base
behind the burner (see Figure 20).
2. Place the base of the middle log (#2) in the U-
shaped slots of the grate base in front of the
back log. The cutout on the right of the middle
log should fit over the burner (see Figure 21).
Make sure the front of the middle log is resting
on the tabs of the grate base and the cutout area
is centered over the burner “U” bend.
3. Locate the recesses on the back of the front
log (#3). Fit these recesses between the posts
of the grate base (see Figure 22).
4. Locate the notches in the bottom of the cross-
over log (#4). Place the crossover log on top
of the middle log and front log. Make sure the
notches of the crossover log lines up with rect-
angular knobs on top of the middle and front
logs (see Figure 23).
5. Place lava rock around base of heater if de-
sired. Do not put lava rock on logs on burner.
INSTALLATION
Continued
Figure 21 - Installing Middle Log (#2)
Burner
Cutout
Tab
U-Shaped Slot
Middle
Log (#2)
“U” Bend
Figure 20 - Installing Back Log (#1)
Pin
Hole in
Grate Base
Back Log
(#1)
Burner
Figure 22 - Installing Front Log (#3)
Figure 23 - Installing Crossover Log (#4)
Crossover
Log (#4)
Notches
Rectangular
Knobs
3
Front
Log (#3)
Post
Recess