Filter
Top Products
EURO 25 -1 35
1. Remove the screens and rod or glass door.
2. Remove the bottom door track.
3. Remove the pilot and valve assembly.
4. Cut the front legs of sandpan with an abrasive cutting disc or plasma cutter. Bend up
sandpan to expose rear legs. Cut rear legs. Cut legs as close to the bottom as possible.
5. Cut out the top front baffle as shown, with an abrasive cutting disc or a plasma cutter.
6. Replace the control cover plate as a support for the insert.
7. The preparation of the host gas fireplace is complete. See Appendix A of the Euro-25-1
manual for further instructions. All installation requirements in the manual must also be
carefully observed and followed.
8. Use Archgard BCV5 connector kit to connect the insert to the host’s B-vent or connect a 4”
diameter flexible aluminum gas vent from the insert to the host’s vent cap.
CAUTION: Installation must be conducted by a qualified gas appliance installer. Gas and
electrical power must be disconnected from the host gas fireplace before
installation can begin.
ITEM 2.
* Optional custom surround is available for the GG 28 Series, Part # GG28BP-25. With this
part, minimal finishing work is required. It will fill in the opening above the insert. Please
contact Archgard Industries for the availability of this part.
ITEM 5.
REMOVE
CUT OUT
2 ½”
24”
INSTALLATION INSTRUCTIONS
INSTALLING THE EURO 25-1 GAS FIREPLACE INSERT HEATING APPLIANCE
INTO VENTED ZERO-CLEARANCE GAS FIREPLACE:
GASGLO MODEL GG 28 SERIES