CyberPower 6 AC and2 usb ports Surge Protector User Manual


 
8-Outlet Surge Protector
(6 AC & 2 USB ports)
CSP604U
CONGRATULATIONS ON YOUR PURCHASE
Thank you for selecting the CyberPower CSP604U Surge Protector.
The information contained on this document explains the features and
operation of the CSP604U. Please take a few moments to read this
manual.
FEATURES
1. ON/OFF Reset Control Switch and Circuit Breaker
Controls power to all outlets. The switch is also a 15A breaker.
When an overload occurs, it will automatically switch off. To
resume operation, ensure the overload condition is removed and
reset the surge protector by switching the unit ON.
2.Surge Protected Indicator
Illuminated when the surge protection is working properly.
3. Six Standard Outlets
4. USB Charging Ports*
Connect and charge up to two (2) USB devices using the surge
protected USB charging ports.
*USB outlets cannot be used as a USB hub. This device does not
transfer data.
SPECIFICATIONS
Model Number: CSP604U
Outlets: 6 Standard Outlets, 2 USB Charger Ports
Surge Protection: 1200 Joules
Electrical Rating: 125V/15A/1875W
UL Clamping Voltage: UL 1449 3
rd
/400V(L-N,L-G,N-G)
Maximum Peak Current: 60,000A
3 AC Lines Protected: L-N:30,000A, L-G:15,000A, N-G:15,000A
(The maximum surge possible on household wiring is 6,000 volts)
Response Time: Less than 1 nanosecond
Attenuation: Up to 32dB
USB charger rating: 5V/2.1A total
Circuit Breaker: Resettable 15 Amp
EMI/RFI Filtration: 150 kHz to 100 MHz
© 2014 CyberPower Systems, Inc.
All rights reserved. All other trademarks are the property of their
respective owners.
K01-0000338-00
User Manual
LIMITED WARRANTY AND CONNECTED
EQUIPMENT GUARANTEE
Read the following terms and conditions carefully before using
the CyberPower CSP604U (the “CPS Product”). By using the
CPS Product, you consent to be bound by the terms and
conditions of this Limited Warranty and Connected Equipment
Guarantee (together referred to as this “Warranty”). IF YOU DO
NOT AGREE TO THE TERMS AND CONDITIONS OF THIS
WARRANTY, YOU SHOULD RETURN THE PRODUCT FOR A
FULL REFUND PRIOR TO USING IT.
Who is providing this Warranty, what does it cover?
CyberPower Systems (USA), Inc. (“CyberPower”) provides this
Limited Warranty. It only covers the original purchaser and ends
if you no longer own the CPS Product. This warranty covers
defects in materials and workmanship in the CPS Product under
normal use and conditions. It also covers equipment connected
to the CPS Product and damaged because of the failure of the
CPS Product. This warranty covers the CPS Product and
connected equipment for as long as you own the CPS Product.
What must I do to make a warranty claim?
1. Call (877) 297-6937 or write to CyberPower, 4241 12th Ave.
E., STE 400, Shakopee, MN 55379 or send a message at
claims@cpsww.com for instructions.
2. Identify the Product, the Purchase Date, and the item(s) of
Connected Equipment.
3. Provide a dated Proof-of-Purchase receipt (or other proof of
the original purchase) and provide a description of the defect.
4. Pack and ship the product to CyberPower and, if requested,
the item(s) of Connected Equipment, and all claim forms that
CyberPower provides to you. Show the Claim Number on the
shipping label or include it with the product. You must prepay
all shipping costs, you are responsible for packaging and
shipment, and you must pay the cost of the repair estimate.
5. Do each of these within ten days of the occurrence.
What will CyberPower do to correct problems?
CyberPower will inspect and examine the CPS Product. If the
CPS Product is defective in material or workmanship,
CyberPower will repair or replace it at CyberPower’s expense, or
CyberPower will refund the full purchase price you paid for the
CPS Product (purchase receipt showing price paid is required).
If the CPS Product failed to protect any equipment plugged into
it, we will also send you forms for making your claim for the
connected equipment. We will repair or replace the equipment
that was damaged because of the failure of the CPS Product or
pay you the fair market value (NOT REPLACEMENT COST)
of the equipment at of the time of the damage. We will use Orion
Blue Book, another a third-party valuation guide, eBay, craigslist,
or other source to establish that amount. Our maximum liability is
limited to $50,000 for the CSP604U.
Who pays for shipping?
We pay when we send items to you; you pay when you send items
to us.
What are some things this Warranty does not cover?
1. THIS WARRANTY DOES NOT COVER ANY SOFTWARE THAT
WAS DAMAGED OR NEEDS TO BE REPLACED DUE TO THE
FAILURE OF THE CPS PRODUCT OR ANY DATA THAT IS
LOST AS A RESULT OF THE FAILURE OR THE
RESTORATION OF DATA OR RECORDS, OR THE REINSTAL-
LATION OF SOFTWARE.
2. This Warranty does not cover: misuse, modification, operation
or storage outside environmental limits of the CPS Product or
the equipment connected to it, or for damage while in transit or
in storage, nor if there has been improper operation or
maintenance, or use with items not designed or intended for
use with the CPS Product, such as laser printers, appliances,
aquariums, medical or life support devices, etc.
What are the other limitations?
The sole and exclusive remedies of the Initial Customer are those
provided by this Warranty.
1. This Warranty does not apply unless the CPS Product and the
connected equipment were connected to properly wired and
grounded outlets (including compliance with electrical and
safety codes of the most current electrical code), without the
use of any adapters or other connectors.
2. The CPS Product must have been plugged directly into the
power source and the equipment connected to the CPS
Product must be directly connected in the CPS Product, not
“daisy-chained” together in serial fashion with any extension
cords, another Product or device similar to the CPS Product,
surge suppressor, or power tap. Any such installation voids
the Warranty.
3. The CPS Product and connected equipment must have been
used properly in a suitable and proper environment, in
conformance with any applicable license, instruction manual,
or warnings.
4. The CPS Product must have been used at all times within the
limitations on the CPS Product’s VA capacity.
Where can I get more information?
Contact CyberPower at 4241 12th Ave E., STE 400, Shakopee,
MN 55379; call us at (877) 297-6937; or send us an e-mail
message at claims@cpsww.com.
PRODUCT REGISTRATION
Prompt product registration assures coverage under the Limited
Warranty, and also allows the opportunity to be notified of
product enhancements, upgrades, and other announcements.
Registration is quick and easy at www.cpsww.com/register.
CONTACT INFORMATION
CyberPower Systems, Inc.
4241 12th Avenue East Suite 400 Shakopee, MN 55379
Toll-free: 1-877-297-6937 | CPSww.com
CONFORMANCE APPROVALS
This device is manufactured using environmentally-safe
procedures in compliance with the Restriction on
Hazardous Substances (RoHS) directive.
Please join CyberPower in caring for the
environment by recycling this manual.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference
that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment. This
Class B digital apparatus complies with Canadian ICES-003.
Note: These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures: Reorient or relocate
the receiving antenna. Increase the separation between the equipment
and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected. Consult the dealer or an experienced radio/TV
technician for help.
This device is manufactured using environmentally-safe procedures in
compliance with the Restriction on Hazardous Substances (RoHS) directive.
CAUTION
TO REDUCE THE RISK OF ELECTRIC SHOCK - Use only in dry
locations and only indoors. DO NOT plug into another relocatable
power tap. DO NOT “daisy chain” surge protectors. DO NOT use
with any aquarium equipment. DO NOT use if properly grounded
outlets are not available. DO NOT install this device if there is
not at least 10 meters (30 feet) or more of wire between the
electrical outlet and electrical service panel. This device features
an internal protection that will disconnect the surge protective
component at the end of its useful life, but will maintain power
to the load – now unprotected.
TROUBLESHOOTING
If the ON/OFF is switched off, the 15 AMP circuit breaker may
have tripped. Examine your connected equipment and remove the
device that is overloading the circuit. Then, turn the ON/OFF
switch back to RESET.
If the Protected indicator does not light, the surge protector’s AC
line is no longer protected from surge. Replace the surge
protector. The surge protector may have received a power surge
or spike beyond its specified limits that overloaded the protection
circuitry and rendered it inactive. The surge protector has
protected your connected equipment but it will not protect against
future surges and spikes.
TECHNICAL SUPPORT
Please contact our Tech Support department with installation,
troubleshooting, or general product questions.
Phone: 1-877-297-6937
Email: tech@cpsww.com
Hours of Operation: Monday – Friday, 8:00am – 5:00pm CST
1
2
4
3