Filter
Top Products
Gas-Fired, Direct Vent
Hot Water Boiler
AVAILABLE FROM:
DIMENSIONS
(
in inches
)
CROWN Co-axial Horizontal Vent Terminal
CWD SERIES SPECIFICATIONS
LOCATING THE BOILER
• Clearances: Sides 1”, front 3”, rear 1”, top 12”
• 6” clearance to air inlet collar when combustion air is supplied from indoors
• Boiler may be installed directly on a non-carpeted combustible floor
• Relief valve may not be moved from factory location
Important: This boiler requires a special venting system.
Read instructions carefully before installing.
Air inlet collar located on center rear of CWD193 through CWD245
Since 1949, homeowners have depended on us
for quality, value and service
3633 I Street, P. O. Box 14818
Philadelphia, PA 19134
Phone: (215) 535-8900 Fax: (215) 535-9736
Visit us on the web: www.crownboiler.com
CWD-11/05-(20M)
PN980528R1
Heat Exchanger constructed and tested in accordance
with ASME Section IV standard.
1. Altitudes above 2,000 ft.–ratings should be reduced at a rate of 4%
for each 1,000 ft. above sea level (U.S.A. only), in Canada, boilers are
certified for altitudes up to 2,000 feet only.
2. Please specify fuel (natural gas or LPG).
3. Specifications and dimensions are subject to change without notice.
*
D.O.E IBR NET COLLAR
NO. OF
AGA
HEATING WATER DIAMETER WIDTH SHIPPING
Model
SECS.
INPUT
CAPACITY RATING
INLET EXHAUST
A AFUE WEIGHT
BTU/HR
BTU/HR BTU/HR. (inches) (inches) (inches) (%)
CWD060 3 60,000 51,000 44,000 4” 3” 16-1/8 85.1 280
CWD083 4 82,500 71,000 62,000 4” 3” 19-3/4 85.1 315
CWD110 5 110,000 94,000 82,000 4” 3” 23-3/8 85.2 350
CWD138 6 137,500 118,000 103,000 4” 3” 27 85.2 385
CWD165 7 165,000 142,000 123,000 4” 3” or 4” 30-5/8 85.2 420
CWD193 8 192,500 165,000 143,000 4” 3” or 4” 34-1/8 85.2 475
CWD220 9 220,000 189,000 164,000 4” 3” or 4” 32-3/4 85.2 525
CWD245 10 245,000 211,000 183,000 4” 3” or 4” 41-3/8 85.3 580