Open as PDF
3-Function Remote Control
Compact 3-Function Remote Control
remote control works only with door
openers and light controls having an orange “Learn”
button and yellow indicator light.
Programming instructions are described and illustrated
below. The additional push buttons can also activate other
garage door openers and/or light controls. (Instructions for
programming light products are included with
Remote Coding Instructions
1. Press and release the “learn” button
on the motor unit. The learn indicator
light will glow steadily for 30 seconds.
2. Within 30 seconds, press and hold the
button on the hand-held remote.
3. Release the button when the motor unit
light blinks. It has learned the code. If
light bulbs are not installed, two clicks will
To Erase All Codes From Motor Unit
To deactivate any unwanted remote, first
erase all codes.
Press and hold the “learn” button on motor
unit until the “learn” indicator light goes out (approximately
6 seconds). All previous codes are now erased.
Reprogram each remote or keyless entry you wish to use.
To order replacement parts call...
The Remote Control Batteries
The lithium battery should produce
power for up to 5 years. To replace
battery, use the visor clip or
screwdriver blade to pry open the
case as shown. Insert battery
matching polarity instructions
inside the remote cover or on the
printed cirucuit board.
Dispose of old battery properly.
3-Function remote control
housing only (No circuit board) . . . . . . . . . . . . . .41A5032
Compact 3-Function remote control
housing only (No circuit board) . . . . . . . . . . . . . .41A5062
3V2032 Lithium battery:
(Models 139.53681B and 139.53680) . . . . . . . . . . .10A20
3V2016 Lithium battery: (Model 139.53681) . . . . . .10A19
Visor clip: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .29B134
Open this end
first to avoid
To prevent possible SERIOUS INJURY or DEATH from a
moving gate or garage door:
• ALWAYS keep remote controls out of reach of children.
NEVER permit children to operate, or play with remote
• Activate gate or door ONLY when it can be seen clearly, is
properly adjusted, and there are no obstructions to
• ALWAYS keep gate or garage door in sight until completely
closed. NEVER permit anyone to cross path of moving gate or
To Control the Motor Unit Lights (Premium
transmitters, a remote push button can be
programmed to operate the motor unit lights without
opening the door.
1. With the door closed, press and hold the remote button
that you want to control the light.
2. Press and hold the Light button on the door control.
3. Press and hold the Lock button on the door control.
4. After the motor unit lights flash, release all buttons.
Test by pressing the remote push button. The motor unit
lights should turn on or off but the door should not move.
To prevent possible SERIOUS INJURY or DEATH:
• NEVER allow small children near batteries.
• If battery is swallowed, immediately notify doctor.
NOTICE: To comply with FCC and or Industry Canada (IC) rules, adjustment or modifications of
this receiver and/or transmitter are prohibited, except for changing the code setting or replacing
the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.
Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.
© 2006, Sears, Roebuck and Co./ ® Registered Trademark / ™ Trademark /
Service Mark of Sears, Roebuck and Co.
® Marca Registrada / ™Marca de Fábrica /
Marca de Servicio de Sears,
Roebuck and Co.