Version 2.0a
2
SAFETY NOTES
The Harvester Model HR-01 biomass fuel stove is significantly different from a conventional wood-
burning stove. One major difference is that the HR-01 requires a reliable source of electrical energy to
properly operate. The owner, installer, and operator must understand this manual and read it in its entirety.
This understanding should be completed and followed before installation or operation of the HR-01 is
attempted. Failure to follow installation and operation instructions may result in property damage, bodily
injury, or even death. Country Flame strongly recommends that a certified professional install the
Harvester Model HR-01.
W
ARNING: THE AUTHORITY HAVING JURISDICTION (such as a municipal building
department, fire department, or fire prevention bureau, etc
) SHOULD BE CONSULTED
BEFORE BEGINNING INSTALLATION. A PERMIT MAY BE REQUIRED IN
ORDER TO PERFORM INSTALLATION.
W
ARNING: It is recommended that a smoke detector be installed in the vicinity of the HR-01.
W
ARNING: Country Flame Technologies has no control over installation maintenance procedures;
therefore, Country Flame grants no warranty, implied or written, for the installation or
maintenance of the HR-01. Further, Country Flame assumes no responsibility for any
consequential damage resulting from said installation or maintenance of this product.
W
ARNING: After operation, always allow the Harvester stove to completely cool before performing
any maintenance operations.
W
ARNING: The HR-01 stove requires reliable electric energy to properly operate. If electrical power
is not available, DO NOT operate a Harvester stove with only natural draft.
W
ARNING: Only a certified professional should install the HR-01 stove and only a qualified service
technician should perform maintenance on this stove. Any parts removed for installation
or servicing must be replaced prior to operational use of this stove.
W
ARNING: Modification of this product is not authorized and any modification voids the Country
Flame warranty.
W
ARNING: The Harvester must be connected to a code compliant grounded 120-volt, 15 ampere, and
60 hertz electrical outlet. Use of a dedicated circuit is recommended. NEVER use an
adapter, extension cord or cut or remove any prong from the power cord.
W
ARNING: NEVER place or store any combustible or flammable products on or near the Harvester.
W
ARNING: The Harvester is designed to immediately shutdown in the event the front door is opened.
Keep the viewing and ash removal door tightly closed during operation. Always clean the
HR-01 after the stove has been allowed to return to normal room temperature.
W
ARNING: Do not connect the Harvester to a chimney flue serving another stove of any type.
W
ARNING: FOLLOW all operating instructions in this manual. Short cuts in operating procedures,
of any kind, can be dangerous.