Filter
Top Products
40
Exploded view and part call-out
Fixture head
indicator
Yoke arm indicator
#10-32 x1"
end screw
1.
To aim fixture, loosen both #10-32 x1 end screws. When the
PointGrab
TM
system indicators are lined up, the slope of the
lens face is 40-degrees. Each subsequent notch is an
additional 10-degrees.
2.
When the fixture head is adjusted to the desired angle, re-
tighten end screws to secure the position.
Mounting yoke to outdoor surface
#10-32 x 1
end screw
(x2)
#6-32 x 1/4"(6.4mm)
x2)
Yoke End Cap
1.
To secure yoke, fixture head must be removed. First, remove
both #10-32 x1 end screws.
2.
Remove
one
#6-32 x.25 screw to remove yoke end cap and
free fixture head. Place both fixture head and yoke end cap
in a safe place.
3.
With fixture head and yoke end cap safely stored, secure
yoke to outdoor surface using the correct fasteners (by
others).
4.
Re-install fixture head by first replacing head with #10-32 x 1
End screw and then securing the yoke end cap using the
#6-32 x.25 screws.
Aiming the fixture
Compatible fasteners
(x2) (by others)
#6-32 x 5/8"(15.9mm)
Socket cap screw
#6-32 x 1/2"(12.7mm)
Socket cap screw (x2)
1/2"(12.7mm) Compression fitting
1.
After installing lamp, fixture head must be sealed by securing
all screws and latches on door face. Holes above latches
receive the #6-32 x.5 socket cap screws. The center hole
receives the longer #6-32 x .625 socket cap screw.
2.
Slide 1/2" compression fitting down fixture head wire and
splice with power feed wire, ensuring all connections are
properly matched. Seal 1/2" compression fitting to outdoor
surface and ensure a watertight seal.
Outdoor
J-box
(by others)
Fixture head
#10-32x1
end screw
(x2)
Yoke end
cap
Yoke
1/2"(12.7mm)
Compression fitting
sealed to wall
#6-32 x 1/4"(6.4mm)
(x2)
#6-32 x 5/8
(15.9mm)
Socket cap
screw
#6-32 x 1/2(12.7mm)
Socket cap screw
(x2)
PG-9 Compression fitting
DO NOT REMOVE
Sealing the outdoor fixture
1/4"(6.4mm)
Screws
(by others)
(x2)
Outdoor J-box
(by others)
Warning
: Before starting any work ensure
that all sources of power are turned off. All
work must meet local/national codes and be
performed by a certified electrician.
Do not
mount fixtures vertically.
Installation Instructions
Vault
C-Scroll
Roundel
These installation instructions are valid with the above Ametrix styles.
1
3
2
Sheet 1 of 2
Small, OUTDOOR
YR
(Y
oke mount
, R
emote ballast
)
Visor and Non-Visor
ADY071443 Rev B (ECN80481)