Filter
Top Products
Vault
1
Sheet 1 of 3
C-Scroll
3
Roundel
2
These installation instructions are valid with the above Ametrix styles.
Visor and Non-Visor
Warning
that all sources of power are turned off. All
performed by a certified electrician.
: Before starting any work ensure
work must meet local/national codes and be
Do not
mount fixtures vertically.
Installation Instructions
Large, OUTDOOR
P1R
(Pendant, 1-way, Remote ballast)
ADY071473 REV A(ECN070347)
(2x)
Mounting and wiring fixture
Mounting plate
#10-32 x 3/8"
Canopy
Hex cap screw
(2x)
1/4-20x 3/4"
(2x)
End screw
Exploded view and part call-out
Pan head screw
#10-32
Appropriate fasteners
(by others)
(2x)
Sealing the fixture
Securing fixture to pendant
(2x)
Socket cap screw
#6-32 x 5/8"
#6-32 x 1/2"
Wire seal
Socket cap screw
1. To seal fixture, secure all socket cap screws according to
sequence and torque specifications on supplementry sheet.
2. Ensure a smooth and sealed connection at wire seal.
3. For aiming instructions refer to aiming supplementry sheet
3.
Mount yoke to pendant with both 1/4-20 Hex cap screws.
Hex cap screw
Wire connector
End screw
Flat head screw
End cap
Yoke
1/4-20 x 3/4"
Mounting plate
#6-32 x 1/4"
(2x)
mounting plate and reattach fixture head to yoke.
Feed fixture wire through connector in pendant up through
(2x)
1. Begin by removing end screw, #6-32 x 1/4" Flat head screw
and end cap from one side of Yoke and remove fixture head.
2.
Fixture wire
#6-32 x 3/8"
(2x)
Replace canopy and secure with both #6-32 x3/8" Pan head
screws.
Attach appropriate wires and ensure all connections are
Attention:
Large fixtures require additional bracing/structure
around J-box to support fixture.
4.
J-box
(by others)
Canopy
properly matched.
Pan head screws
1. Loosen #6-32x 3/8" Pan head screws and allow canopy to slide
down pendant.
2. Feed wires from J-box through wire ways in mounting plate
and secure fixture to bracing around J-box.
3.
Use additional bracing
around J-box to support
fixture.Appropriate
fasteners
(by others)
(4x)