Filter
Top Products
Vertical Wall
(Grazed Surface)
Ceiling
Blocking
FIGURE 1
2. The Trim of the Stealth Graze must now be removed so that
access can be gained to the Thermal Protector. This step may
be skipped if blocking is not in the way of the Thermal
Protector or a different mounting method is being used. Place
the Utility Wedge between the Trim and the Plaster Frame and
push straight up until the Trim pops out. (Figure 2) Do not
bend the Utility Wedge while in the Fixture, as it might break.
Utility Wedge
Trim
Plaster Frame
Thermal Protector
FIGURE 2
3. Once the Trim is removed, the Thermal Protector should be
pulled inside the Housing so that the Fixture will slide past
the Blocking. To do this, reach inside the Housing, unscrew
the Thumb Screw, and pull the Thermal Bracket (with the
Thermal Protector attached) into the Housing. (Figure 3)
The Fixture can now be hoisted into the ceiling for mounting.
Housing
FIGURE 3
Thumb Screw
Thermal
Bracket
Thermal
Protector
4a.If two or more Stealth Graze Housings are being used, align
Housings into Ceiling, butting fixtures end to end tightly. Place
two (2) Connecting Screws through Connecting Holes on
Housings, and secure with Connecting Nuts. (Figure 4)
4b.Once the Fixture is placed into the ceiling, it can be secured
using countersunk screws. Fixture should be mounted by
screwing through the Plaster Frame (screw holes are already
countersunk) and into the blocking. (Figures 5 & 6) If additional
screw locations are needed, there is a screw line in the Plaster
Frame extrusion to facilitate this process.
Connecting Screws
Connecting Nuts
Connecting
Holes
Housing A
Housing B
FIGURE 4
FIXTURE MOUNTING
1. Before Stealth Graze can be installed, blocking should be
installed above ceiling around the fixture. (Figure 1)
V90181
STEALTH GRAZE
FIXTURE MOUNTING
FIXTURE MOUNTING
1. Before Stealth Graze can be installed, blocking should be
installed above ceiling around the fixture. (Figure 1)
V90181
STEALTH GRAZE
FIXTURE MOUNTING
7945 Orion Avenue, Van Nuys, CA 91406 818-349-3030/ 800-356-3030 FAX 818-349-3031
Visit our web site at: www.rsalighting.com
C
Avoid Fire or Electric Shock
L
US
*Installation Instructions for qualified electricians only.
*Install per National Electrical Code and local regulations.
*Read Installation Instructions completely before installation.
*Failure to follow Installation Instructions may void warranties.
U
INSTALLATION INSTRUCTIONS
RSA Lighting
R