Filter
Top Products
Exploded view and part call-out
Canopy
Set screw
1/4-20 x 4 1/2"
Hex cap bolts
(4x)
(by others)
J-box
#8-32 x3/8"
(2x)(4x)
1/4" Fastener
Cover plate
Wiring the fixture
1.
Remove all 1/4-20 x4 1/2" hex bolts from bottom of pendant.
2.
Remove both #8-32 x 3/8" set screws and allow canopy to
slide down pendant.
3.
Run wires from J-box into pendant, ensure there is enough
wire to reach cover plate.
4.
Using appropriate fasteners, secure fixture to ceiling.
Use
additional bracing around J-box to support fixture.
5
. Replace canopy and secure using both set screws.
Yoke arm
indicator
Aiming the fixture
Fixture head
indicator
1.
To aim fixtures, loosen both #10-32 end screws on
one
fixture. When both indicators are lined up, the slope of the
lens face is 40-degrees. Each subsequent notch is an
additional +/- 10-degrees.
2.
When fixture head is rotated to the desired angle, retighten
end screws to secure the position.
3.
Repeat for remaining fixture heads.
Set screw
Mounting pendant to J-box
(4x)
(by others)
1/4" fasteners (by others)
J-box
(2x)
(4x)
Hex cap bolts
1/4-20 x4 1/2"
#8-32 x3/8"
Canopy
Cover plate
Use additional bracing
around J-box to support
fixture.
4.
Cover plate
Push connections into pendant and secure cover plate.
properly matched.
1/4-20 x4 1/2"
Fixture wire
Hex cap bolts
(4x)
1.
With pendant secure, slide fixture assembly onto pendant
and secure with four 1/4-20 x4 1/2" hex bolts.
2.
Remove cover plate and insert wires from fixture heads into
pendant and pull through opening.
3.
Attach appropriate wires and ensure all connections are
Attention:
Quad fixture assemblies require additional bracing/structure
around J-box to support fixture.
2
that all sources of power are turned off. All
Sheet 1 of 2
performed by a certified electrician.
ADY071466 REV B(ECN80481)
Warning
: Before starting any work ensure
work must meet local/national codes and be
Do not
mount fixtures vertically.
Installation Instructions
Vault
C-Scroll
Roundel
These installation instructions are valid with the above Ametrix styles.
1
3
Small, INDOOR
P4R
(P
endant,
4
-way,
R
emote ballast
)
Visor and Non-Visor