Filter
Top Products
IMPORTANT SAFETY
INSTRUCTIONS
WHEN USING ELECTRICAL APPLIANCES, BASIC
SAFETY PRECAUTIONS SHOULD ALWAYS BE TAKEN,
INCLUDING THE FOLLOWING:
READ ALL INSTRUCTIONS BEFORE USING
APPLIANCE.
DANGER- TO REDUCE THE RISK
OF ELECTRIC SHOCK: ALWAYS UNPLUG THIS
APPLIANCE FROM THE ELECTRICAL OUTLET
BEFORE CLEANING.
WARNING–TO REDUCE THE RISK
OF BURNS, ELECTROCUTION, FIRE, OR INJURY TO
PERSONS:
1. Unplug from outlet before putting on or taking off
parts.
2. This mirror should not be used by or near children
or individuals with certain disabilities.
3. Use this mirror only for its intended use as
described in these instructions. Do not use attach-
ments not recommended by the manufacturer.
4. Never operate this mirror if it has a damaged cord
or plug, if it is not working properly, if it has been
dropped or damaged, or dropped into water. Return
the mirror to a service center for examination and
repair.
5. Keep the cord away from heated surfaces.
6. Never drop or insert an object into any opening.
7. Do not use outdoors.
8. Do not operate where aerosol (spray) products are
being used or where oxygen is being administered.
9. To disconnect, turn all controls to the off position,
then remove plug from outlet.
10. Unplug the appliance from outlet before cleaning.
Do not leave appliance unattended when it is
plugged in.
11. Be sure mirror is not in a position where it can
reflect sunlight; reflected sunlight can cause fire.
12. Do not use on a soft surface such as a bed, where
openings may be blocked.
13. Touch mirror base until light shuts off, allow unit
to cool and unplug cord before replacing light bulbs.
14. Do not place or store appliance where it can fall
or be pulled into a tub or sink.
15. If an appliance falls into water, unplug it immedi-
ately. Do not reach into the water.
16. To protect against electrical hazards, do not use
while bathing or in the shower.
17. Never use while sleeping.
18. Do not use a bulb greater than 20 watts.
Use on any 120 volt 60 hertz AC electric outlet
(ordinary house current). Do not use it on any other
electrical outlet. There is an electric outlet in the base.
Do not plug any appliance over 12 amperes into
the base.
FOR HOUSEHOLD USE ONLY
SAVE THESE
INSTRUCTIONS
OPERATING
INSTRUCTIONS
To reduce the risk of electric shock, this mirror has a
polarized plug (one blade is wider than the other). This
plug will fit in a polarized outlet only one way. If the plug
does not fit fully in the outlet, reverse the plug. If it still
does not fit, contact a qualified electrician to install the
proper outlet. Do not change the plug in any way.
CAUTION: BE SURE DIRECT SUNLIGHT DOES NOT
STRIKE MAGNIFYING SIDE OF MIRROR WHEN
LEFT UNATTENDED; REFLECTED SUNLIGHT CAN
CAUSE FIRE.
1. Your Infiniti
™
by Conair
®
makeup mirror will rotate
360° so that you can use either the standard, flat
mirror or the 7x magnifying mirror located on the
opposite side.
2. The mirror is uniquely designed with a 10x spot
magnification mirror which helps to flawlessly shape
eyebrows, apply makeup, or insert contact lenses.
3. Plug into any standard 120 volt wall outlet. The
mirror light is activated by touch. Touch the base to
control the light settings. The first touch will turn the
light on to the low setting. A second and third touch
will change light settings to medium and high. A fourth
touch will turn off the mirror light.
4. After use, always touch the base to turn the mirror to
the off position and unplug.
5. This mirror features an electrical outlet in the base.
Power ratings on appliances plugged into this electrical
outlet should not exceed 12 amperes (Figure 1).
6. The beauty and design of this mirror complements
any decor. Therefore, you may wish to leave the mirror
displayed. However, if you choose to store the mirror,
see “STORAGE” for detailed information.
TO REPLACE BULB
CAUTION: TURN OFF POWER AND UNPLUG. ALLOW
TO COOL AT LEAST 3 MINUTES BEFORE REPLACING
BULB. REPLACE BULB ONLY WITH BULB OF SAME
WATTAGE RATING.
Contact a Conair service center at 1-800-3 CONAIR for
replacement bulb information (ask for replacement bulb
#RP34. Bulbs are $1.50 each, including shipping and
handling).
1. Remove screws from left and right sides of mirror
(Figure 2).
2. Carefully lift off the removable housing from the half
that is affixed to the stand.
3. Unscrew the old bulb and replace with the
new bulb (Figure 3).
Figure 2
Figure 3
Figure 1