Filter
Top Products
Page 18SKU 90715
Button Sewing
1. Measure the distance between the button holes and select the appropriate pattern
number using the Pattern Selection Dial (11).
2. Change the Presser Foot to the Button Sewing Foot.
3. Place the darning plate on the needle plate.
4. Place a button between the foot and the fabric, aligning the thread holes in the button
with the machine needle.
Turn the Balance Wheel (9) to make sure the needle enters the holes without hitting
the button. If it hits, change the pattern number (see step 1).
5. At slow speed, sew about 10 stitches.
6. Remove the material from the machine.
Cut the upper and lower threads and tie both threads at the back of the material.
Button Sewing Foot
Distance between holes Pattern No.
1.5 mm (1/16”) 4
3.5 mm (9/16”) 5
5 mm (13/64”) 6