Open as PDF
Models: 6405/4410 & 6405/4410TK GM/Chevrolet 2007 – current (new body style) full size trucks and
SUVs with manual power mirrors.
THIS SET IS DESIGNED FOR TRUCK WITH STOCK MANUAL MIRRORS. IF YOU
CURRENTLY HAVE POWER MIRRORS, THE WRONG SET HAS BEEN ORDERED.
Caution! - Do not attempt to manually extend or retract the mirrors. They should be moved under their own
motor power only.
Tools required for the installation are: 7mm and 10mm sockets, trim panel remover, philips screwdriver, small
screwdriver, needle nose pliers, razor knife, and an inch pound torque wrench. If you have any questions after
reading this installation manual, please call our service department at (800) 337-2557.
REMOVAL OF EXISTING MIRRORS
1. On the inside of the driver’s door, remove the triangular shaped trim piece and insulation foam in the
mirror mounting area.
2. Remove the door lock by using a small screwdriver to release the tab
while lifting the lock upward.
3. Remove door trim panel screws located under trim covers.
4. Remove window handle by releasing the retaining clip.