Filter
Top Products
Introduction
Q-Wash 250 User Manual 7 2006-05-17/13:18
E
x
t
e
r
i
o
r
s
u
r
f
a
c
e
t
e
m
p
e
r
a
t
u
r
e
T
=
8
0
°
C
WARNING!
Wait at least 15 min. before opening
the covers and removing
X
Y
Z
A
C
B
Lamp Alignment Screws, A, B & C
100V
100V
115V
115V
208V
208V
230V
230V
240V
240V
50Hz
50Hz60HzININ
60Hz
Select voltage
To Ballast 230V/50Hz
To Ballast 230V/60Hz
Lamp Control to PCB in
AC-100-230V
INPUT
To TRANSFORMER
Lamp Alignment How-To
Often, after a new installation of a lamp, you will find that there is an uneven field of light or what is
referred to as a hot spot. This is due to the most intense point of the lamp source not being positioned
optimally within the reflector.
There are three lamp alignment screws provided at the base of the
projector head. Turning these screws allow you to optimize the
projection quality of the spot as well as the overall intensity of the
beam.
1. Project a white spot against any flat surface. Preferably the
surface should be white or pastel in color.
2. Turning the lamp alignment screws, try to position the hot spot
in the center of the beam as best as possible. This could require
many attempts on your part.
3. Once the hot spot is in the center of the spot, do your
best to turn all screws equally as to affect movement up
or down within the reflector.
4. As you move in and out of optimum lamp focus, you will see
the hot spot either gets wider or narrower. The goal is to either
totally diminish the hot spot by having it widen and spread
across the entire spot or moving the hot spot so that it covers
as much of the beam spot area as possible.
Power
Warning! Verify that the internal multi-tap transformer is set to match the line voltage applied
and that the proper fuse is installed for the appropriate voltage setting. All fixtures
must be connected to circuits with a suitable Earth Ground.
To determine the power requirements for
a particular fixture, see the label affixed to
the back plate of the fixture or refer to the
fixture’s specifications chart.
A fixture’s listed current rating is its
average current draw under normal
conditions.
All fixtures must be powered directly off a
switched circuit and cannot be run off a
rheostat (variable resistor) or dimmer
circuit, even if the rheostat or dimmer
channel is used solely for a 0% to 100%
switch.
Before applying power to a fixture, check
that the source voltage matches the
fixture’s requirement.
All fixtures must be connected to circuits with a suitable Earth Ground.
POWER CABLE PIN INTERNATIONAL
BROWN
Live L
BLUE
Neutral N
YELLOW/GREEN
Earth EG (Ground)
OPERATING VOLTAGE MUST USE CORRECT FUSE
120V
6.3A
230V
3.15A
CAUTION!
This lighting
fixture comes
from the
factory with a
120V fuse pre-
installed. To
operate this
fixture in 230V,
please replace
the external
fuse with the
supplied 230V
fuse.