Chatsworth Products 16147-054 Door User Manual


 
P R O D U C T A P P L I C AT I O N
Keypad Module (recommended) — Enter an
authorized access code on the Keypad Module to
open a handle. The Keypad Module can be placed
on or near the cabinets and can open any of the
cabinet handles in the system.
Communications Module (required) — Provides a single IP
addressable network connection for the Electronic Locking
System and is used to setup and configure the system.
Each Communications Module can support any
combination of up to 64 Electronic Lock Control
Modules (512 handles, 256 cabinets), 64 Keypad
Modules and 64 Proximity Card Reader Modules. Control
access to equipment with computer terminals using the
included lock control software. Provide alarm outputs for
unauthorized entries. The software also keeps a log of
each access attempt and all configuration changes.
Electronic Lock Upgrade Kit (required)
— Replace the mechanical lock on the
cabinet’s swing handle with an electronic
solenoid that releases the spring-loaded
handle when the correct code is entered.
When the correct code is entered, the
handle springs open allowing the door to
be opened.
800-834-4969
techsupport@chatsworth.com
www.chatsworth.com
Electronic Locking System
Electronic Lock Upgrade Kit (2 per cabinet)
with Electronic Lock Extension Cable
Electronic Lock Control Module (8 handle)
Proximity Card Reader Module
Keypad Module
with Keypad Module Cable
Communications Module
Electronic Lock Control Module (required) —
Connects upgraded electronic locks to the
Electronic Locking System and controls the
solenoid that opens the cabinet handles.
Each Electronic Lock Control Module
connects eight handles (four cabinets) to
the system. Each handle can have up to
five access codes and can be assigned to
24 user groups. The Electronic Lock Control
Module also reports the status of the handle
(opened or closed).
Proximity Card Reader Module (optional) — Use with the
Keypad Module. The proximity card acts like a key replacing the
access code. The proximity card can be programmed with a
specific handle access code or with up to 24 user group codes to
open multiple cabinets. Proximity cards can also be programmed
to open handles a specific number of times and to expire at a
specific time and date.
Electronic Locking System For CPI Cabinets
Automate access control and monitoring in your data center, computer
room and network facilities with the Electronic Locking System.
• Automate data center cabinet access control and monitoring
• IP addressable system increases security
• Assign and program individual user ID access codes
• Access cabinets via a network-connected computer, keypad or
proximity cards
• Create a log entry for each access attempt and configuration change
• Monitor handle conditions — opened or closed
• Forward SNMP traps to designated computers during alarm conditions
• Quickly update the system configuration and users privileges
• Easily add modules as your network grows
Rear
View