Filter
Top Products
Universal Garage Door Opener Remote Control
To prevent possible SERIOUS INJURY or DEATH from a moving gate
or garage door:
• ALWAYS keep remote controls out of reach of children. NEVER
permit children to operate, or play with remote control transmitters.
• Activate gate or door ONLY when it can be seen clearly, is properly
adjusted, and there are no obstructions to door travel.
• ALWAYS keep gate or garage door in sight until completely closed.
NEVER permit anyone to cross path of moving gate or door.
Remote
Control
Motor Unit
& Receiver
DIP Switches or
Smart-Learn Button
External Ceiling or
Wall Mounted Receiver
CLICKER
Model No. CLT1
The Clicker remote can be programmed to operate up to 2
garage door openers or gates, including different brands. All
programming is done using the:
• Brand switches
• Remote control DIP switches
• Remote control push buttons
A and B, and LED indicator
WARNING
CAUTION
WARNING
WARNING
ON
ON
BRAND Switches
UP position is ON
DOWN position is OFF
DIP Switches
UP position is ON
DOWN position is OFF
NOTE: Use pen or small screwdriver
to move dip switches.
Button A
Button B
LED
DIP
Switches
BRAND
Switches
Battery
Slide Battery
cover down
to remove
PREPARATION
Determine the BRAND of the existing garage door opener or
handheld remote controls. If all remote controls are lost, the
BRAND is located on the ceiling mounted motor unit or on the
external receiver near the flexible wire antenna. Also determine
if your motor unit/receiver system has DIP switches or a
smart-learn button. (Some models require removing the light
lens.) Proceed to Step 1 for your specific BRAND switch. For
further information consult your garage door opener manual.
■ Set brand switches on Clicker
remote. Refer to Table 1.
Step 1 - Set Brand Switch
▼
Table 1 (Brand Switches)
➡
FREQ.
SYSTEM MHZ BRAND SWITCHES
STANLEY 10 DIP Switches 310 OFF OFF OFF OFF
MULTI-CODE 10 DIP Switches 300 ON OFF OFF OFF
LINEAR/MOORE-O-MATIC 8 DIP Switches 310 OFF ON OFF OFF
GENIE 9 DIP Switches 390 OFF OFF ON OFF
GENIE 12 DIP Switches 390 ON OFF ON OFF
CHAMBERLAIN, SEARS,
LIFTMASTER, MASTER MECHANIC,
OR DO IT 7 Dip Switches 390 ON OFF OFF ON
CHAMBERLAIN, SEARS,
LIFTMASTER, MASTER MECHANIC,
OR DO IT 8 Dip Switches 390 OFF OFF OFF ON
CHAMBERLAIN, SEARS,
LIFTMASTER, MASTER MECHANIC,
OR DO IT 9 Dip Switches 390 ON ON OFF OFF
CHAMBERLAIN, SEARS,
LIFTMASTER,
MASTER MECHANIC, DO IT:
YELLOW/WHITE/GRAY Smart-Learn Button 390 ON ON OFF OFF
Proceed to Step 2.
If you have a Green or Orange/Red Smart-Learn Button
proceed to Step 3.
CHAMBERLAIN, SEARS,
LIFTMASTER,
MASTER MECHANIC, DO IT,
GREEN Smart-Learn Button 390 ON ON ON OFF
CHAMBERLAIN, SEARS,
LIFTMASTER,
MASTER MECHANIC, DO IT:
ORANGE/RED Smart-Learn Button 390 OFF ON ON OFF