Filter
Top Products
Children operating or playing with a garage
door opener can injure themselves or others.
The garage door could close and cause
serious injury or death.
Do not allow children
to operate the Door Control or remote control
transmitter(s).
A moving garage door could injure or kill
someone under it.
Activate the opener only
when you can see the door clearly, it is free of
obstructions, and is properly adjusted.
NOTICE: To comply with FCC/IC rules, adjustment or modifications of
this receiver and/or transmitter are prohibited, except for changing the
code setting or replacing the battery. THERE ARE NO OTHER USER
SERVICEABLE PARTS.
Your garage door opener receiver and remote control
transmitter have been set at the factory to a matching
code. The door will activate when the remote control
push button is pressed.
Your "Smart" garage door opener will operate with:
• up to four "Smart" remote control transmitters
(with green indicator lights),
• a Keyless Entry System, and
• code switch transmitters with red indicator lights.
Below are instructions for programming your opener
to match any additional remotes you may purchase.
See available accessories on page 34.
To Add A Remote
1. Press and
hold
the remote push button. See
Figure 1.
2. Then press and release the "Smart" button on the
right side of the opener in Figure 2. The opener
lights will
flash once.
3. Release the remote push button.
Now the opener will operate when the remote control
push button is pressed.
If you release the remote control push button
before the opener lights flash, the opener will not
accept the code.
To Erase All Remote Control Codes
• Press and hold the "Smart" button on the opener
panel until the indicator light turns off (about 6
seconds).
All
the codes the opener has learned
will be erased.
• To reprogram, repeat Steps 1 - 3 for each remote
control in use.
Single Function Remote Control
Push Button
Battery
Indicator Light
Garage Door Opener
(With "Smart" Button)
"Smart"
Button
Indicator
Light
KG
KG
1
3
9
7
5
1
3
9
7
5
1
2
3
Code programming instructions are also located
on the opener panel.
WARNING
Figure 1
Figure 2
Receiver and Remote Control Programming
29