Vermont Casting SR18SHK Indoor Fireplace User Manual


 
410 Admiral Blvd. • Mississauga, Ontario, Canada L5T 2N6 • 905-670-7777
www.majesticproducts.com • www.vermontcastings.co
CFM Specialty Home Products
Decorative Gas Appliance for Installation in Solid Fuel Burning Fireplace
ATTENTION
Installation, service and repair of this appli-
ance must be performed by a qualified in-
staller, service agency, company or gas
supplier experienced with this type of gas
appliance.
Installer:
Read this instructions completely and carefully
prior to beginning installation. After installation,
leave these instructions with the owner.
Owner:
Read these instructions and follow the warnings.
Save this manual for future reference.
Please record your gas log’s model number
for future reference here:
NOTE: This model # can be found on the box
or the label attached to the back of the burner
pan.
WARNING
When used without fresh air, this unit may give off carbon monoxide, an odorless, poisonous gas. You
must make adequate provision for accessibility and for combustion and ventilation of fresh air supply.
DANGER! CARBON MONOXIDE POISONING MAY LEAD TO DEATH
3311956 12/04 Rev. 5
Installation and Operating
Instructions for
Vented Gas Log Sets -
Standard Hearth Kits
LISTED BY
LISTING NO. 1254
Models: SR18SHK, SR24SHK, SR30SHK
WARNING
If the information in this manual is not followed exactly, a fire or explosion may result causing
property damage, personal injury or loss of life.
Do not store or use gasoline or other flam-
mable vapors and liquids in the vicinity of
this or any other appliance.
WHAT TO DO IF YOU SMELL GAS
Do not try to light any appliance.
Do not touch any electrical switch; do not
use any phone in your building.
Immediately call your gas supplier from a
neighbor’s phone. Follow the gas
supplier’s instructions.
If you cannot reach your gas supplier, call
the fire department.
Check local codes before installing this log set. In
some areas of the country, gas log sets are
restricted.
The installation and the provisions for combustion
and ventilation air must conform with the National
Fuel Gas Code, ANSI Z223.1.