Vermont Casting DV36/39 Indoor Fireplace User Manual


 
KT233
DV36/39 bay front
window panel
6/20/01 djt
DV36/39 STKP and
CBTK
Bay Front Kits
Installation Instructions
Please read these instructions before beginning
assembly.
Caution
Porcelain enamel is fragile. The finish can be eas-
ily damaged if castings are not handled carefully.
Always place castings on a protective surface, such
as a towel, blanket or carpet.
Carefully unpack the Front Face components and in-
spect for damage. Report missing or damaged parts to
your dealer immediately.
Kit Contents
Upper Grille Assy. Base Grille Assy.
Window Assy. Base Trim Piece
Hanger Brackets, 2 Knob Ext., Hi/Lo
Knob Ext., Philostat Knob Ext., Piezo
Knob, Off/On Ext. SIT#916.188
Knob, HI/LO Ext., SIT#916.189
#10 x 1/2” sheet metal screws, 2
Ceramic Refractory, 2
You will need a Phillips screwdriver to install the front.
The fireplace installation should be complete and in
-
spected. Any surround and trim assemblies should also
be installed before setting the front face in position.
Installation
1. Remove the upper louvre section from the DV fire-
box front.
2. Fasten the two top brackets at the existing holes in
the upper inside lip of the firebox. Use the left hole
on the left bracket and the right hole on the right
bracket. (Fig. 1)
3. Place two (2) ceramic refractory pieces into window
assembly. (Fig. 2) CAUTION: The ceramic refractory
pieces are very fragile, handle with care!
KT232
DV36/39 bay front
hanger brackets
6/19/01 djt
Top Hanger
Brackets
Use the
outermost
hole
KT232
Fig. 1 Be sure that each of the steel brackets is securely at-
tached to the fireplace frame.
KT233
Upper Rail
Fig. 2 Cast window panel shown, Steel window mounts in the
same manner.
5. The base trim piece is used to close a gap that might
exist between the base grille and a lower hearth.
Attach the trim section to the base grille by engaging
the narrow flange to the clips on the underside of the
base grille. (Fig. 3)
30000429 8/08 Rev. 4
4. Hang the window panel on the firebox front by en-
gaging its upper rail over the back of the top of the
firebox opening frame. (Fig. 2)
Remove the protective film from the brass trim
sections, if applicable.
Ceramic
Refractory
Ceramic
Refractory