Cadet RM162 Electric Heater User Manual


 
Features
&
Benefits
Thermal Safeguard:
High temperature manual reset:
turns off heater if normal operating
temperatures are exceeded
Commercial grade steel element
Powder coat paint process eliminates
sharp cutting edges
Five year extended warranty
Wall can designed for ease of
installation
Optional double pole field mount
thermostat kit available
Factory tested
MODELS:
RM202 RM208 RM108
RM151 RM162
Note: Thermostat not included
Dimensions in
inches (cm)
WARNING
Turn the electrical power off at the electrical
panel board (circuit breaker or fuse box) and lock
or tag the panel board door to prevent someone
from turning on power while you are working on
the heater. Failure to do so could result in serious
electrical shock, burns, or possible death.
SAVE THESE INSTRUCTIONS
1. Read all instructions before using this heater.
2. Read all information labels. Verify that the electrical supply
wires are the same voltage as the heater.
3. All electrical work and materials must comply with the
National Electric Code (NEC), the Occupational Safety and
Health Act (OSHA), and all state and local codes.
4. Connect the grounding pigtail (copper wire) provided in the
wall can to the supply ground wire.
5. If you need to install a new circuit or need additional wiring
information, consult a qualified electrician.
6. Protect electrical supply from kinks, sharp objects, oil,
grease, hot surfaces or chemicals.
7. WARNING
Overheating or fire may occur. DO NOT install the heater in a
floor, ceiling or behind doors.
8. WARNING
Fire or explosion may occur. DO NOT install heater in any
area where combustible vapors, gases, liquids, or excessive
lint or dust are present.
9. WARNING
Burn Hazard. This heater is hot when in use. To avoid
burns, do not let bare skin touch hot surfaces. Use extreme
caution when any heater is used by or near children or
invalids.
10. WARNING
Risk of Electrical Shock. Connect grounding lead to grounding
wire provided. Keep all foreign objects out of heater.
11. WARNING
Risk of Fire. Do not block heater. Heater must be kept clear of
all obstructions: a minimum of 3 feet in front, 6 inches
above and on both sides. Heaters must be kept clean of lint,
dirt and debris. (See Maintenance Instructions).
12. Use this heater only as described in this manual. Any
other use not recommended by the manufacturer may
cause fire, electrical shock, or injury to persons.
IMPORTANT INSTRUCTIONS
Tools Required:
Phillips Screwdriver
Straight Screwdriver
Wire Strippers
Utility Knife
(4) 1½“ Wood Screws
(3) Insulated Wire Connectors
(1) Strain Relief Connector
OWNER’S
GUIDE
The
Register
Plus
TEL: 360-693-2505 Fax: 360-694-8668 P.O. Box 1675 Vancouver, WA 98668-1675
Grill Front
Wall Can Front
4"T
10,16
2"T
5,08
3
/4"T
1,91
1"T
2,54
2
1
/2"T
6,35
3
3
/8"T
8,57
T
45˚
T
Wall Can Side
5
7
/8"T
14,92
1"T
2,54
2"T
5,08