Filter
Top Products
240/208 VOLT MODELS
2F350 6F1500
2F500 8F2000
3F750 8F2500
4F1000 8F2025
5F1250 10F2500
208 VOLT MODELS
2F500-8 3F750-8 4F1000-8
5F1250-8 6F1500-8 8F2000-8
8F2500-8
120 VOLT MODELS
2F500-1 3F750-1 4F1000-1
6F1500-1
The Cadet
Electric Baseboard
OWNER’S GUIDE
IMPORTANT INSTRUCTIONS
SAVE THESE INSTRUCTIONS
WARNING!
Turn the electrical power off at the electrical
panel board (circuit breaker or fuse box) and
lock or tag the panel board door to prevent
someone from turning on power while you are
working on the heater. Failure to do so could
result in serious electrical shock, burns, or
possible death.
1. Read all instructions before using this heater.
2. Read all information labels. Verify that the electrical supply
wires are the same voltage as the heater.
3. All electrical work and materials must comply with the
National Electric Code (NEC), the Occupational Safety and
Health Act (OSHA), and all state and local codes.
4. The heater must be grounded to the grounding pigtail (copper
wire) provided.
5. If you need to install a new circuit or need additional wiring
information, consult a qualified electrician.
6. Protect electrical supply from kinks, sharp objects, oil, grease,
hot surfaces or chemicals.
7. Do not place heater against paperboard or low-density
cellulose fiberboard surfaces.
8. Do not place heater below an electrical convenience receptacle.
9. WARNING
Overheating or fire may occur. Do not install the heater behind doors.
10. WARNING
Fire or explosion may occur. Heater has hot and arcing or sparking
parts inside. Do not install heater in any area where combustible
vapors, gases, liquids, or excessive lint or dust are present.
11. WARNING
Burn Hazard. This heater is hot when in use. To avoid burns, do
not let bare skin touch hot surfaces. Use extreme caution when
any heater is used by or near children or invalids and whenever
the heater is left operating unattended.
12. WARNING
Risk of electrical shock. Keep all foreign objects out of heater.
Do not operate after heater malfunctions or has been dropped
or damaged in any manner.
13. WARNING
Risk of Fire. Do not block heater. Heater must be kept clear of
all obstructions: minimum of 12 inches in front and above,
6 inches on both sides. Heaters must be kept clean of excessive
lint, dirt and debris. (See Maintenance Instructions)
14.Use this heater only as described in this manual. Any other use
not recommended by the manufacturer may cause fire, electrical
shock, or injury to persons.
Features & Benefits
•
Oversized high temperature limit switch with full
length sensor for added safety
•
Durable steel sheathed element with a limited
lifetime warranty
•
Easy installation with pre-punched case at 1” intervals
•
Rugged steel construction
•
Thermostat not included
www.cadetco.com Tel: 360-693-2505 P.O. Box 1675 Vancouver, WA 98668-1675
TOOLS REQUIRED
•
#2 Phillips
Screwdriver
•
Straight
Screwdriver
•
Wire Strippers
•
Drill or Hammer
•
Drill Bits
•
(4) Wood Screws
•
Wire Connectors
•
(1) Strain Relief
Connector