Filter
Top Products
ELECTROCHEMICAL
CO SENSOR
Most accurate technology available for
detecting carbon monoxide as compared to
other sensing technologies.
TWO SILENCE
FEATURES
Silences low battery chirp for up to
eight hours or silence nuisance alarm
for several minutes.
END OF LIFE SIGNAL
Provides audible notice when alarm
needs to be replaced.
TAMPER RESISTANT
LOCKING PIN
Locks alarm cover to prevent
removal of battery. Perfect for
apartment, dormitory or hotel
applications.
9V BATTERY
INCLUDED
Available in the following versions:
CO250B Alkaline Battery
CO250LB Long Life Lithium Battery
CAT.
CO250B/CO250LB
9V Battery Powered
CO
BRK Model CO250 is a single station carbon monoxide alarm specifically
designed for residential and institutional applications including sleeping rooms of
hospitals, hotels, motels, dormitories, and other multifamily dwellings as defined
in standard NFPA 101. Model CO250 has been fully tested and complies with,
UL2034, NFPA 720, and NFPA 101 and other agencies that model their codes
after the above agencies. It meets building codes where battery operated
carbon monoxide alarms with silence are required and with model building
codes published by the ICC.
BRK Model CO250 is a state of the art carbon monoxide alarm designed to
provide early warning of the presence of carbon monoxide. It features an
electrochemical carbon monoxide sensor, an 85dB horn, a full function test
switch and a red LED light that indicates DC power or alarm. The CO250B
features a 9V alkaline battery and the CO250LB a 9V long life lithium battery.
This alarm has two silence features. Low Battery Silence: Temporarily silence the
low battery chirp for up to eight hours. Alarm Silence: Silence alarm for several
minutes. It also features a tamper resistant locking pin that locks alarm cover to
prevent removal of battery. Perfect for apartment, dormitory or hotel applications.
The compact, low profile design complements any décor. Battery installation and
removal can occur while the unit is mounted to the ceiling or wall via the hinged
cover. When voltage drops to a pre-set warning level, the horn will “chirp”
approximately once per minute to indicate a fresh battery is needed. To insure
the battery is always replaced properly, the cover
is designed to resist closing when the
battery is missing. Designed
for wall or ceiling
mounting. Includes
mounting
anchors and
screws.
ver
he
CARBON
MONOXIDE
ALARM
7