Filter
Top Products
D. AS A BUILT-IN FIREPLACE
Figures 16 and 17 describe a P2000 installation vented into either
a special chase built outside an outer wall or a false inside wall.
This is especially suited for new construction or remodeling.
The equipment compartment (sides and rear of the stove in
fireplace) must be enclosed per the applicable electrical standards.
NOTE: Floor protection for Built-in raised hearths requires a
continuous sheet beneath to prevent the possibility of embers
falling through to the combustible floor if cracks or separation
should occur in the finished surface.
The chase dimensions shown are minimums and must be
maintained.
INSTALLATION
12
FIGURE 16
FIGURE 17