Filter
Top Products
INSERT INSTALLATIONS
Insert installations must be vented with 3” or
4” pipe. Pipe may be single wall stainless
steel flexible pipe. Vent may terminate within
chimney beyond a blanking plate or extend
to the chimney top. See “COMBUSTION AIR
SUPPLY” for outside air access information.
The fireplace and chimney should be
cleaned thoroughly before starting the
installation. We suggest painting the interior
of particularly old and dirty fireplaces to seal
any odors. In zero-clearance fireplace
installations, when the fireplace opening is
above the floor or raised hearth, the
adjustable “Breckwell P2000 Z-C Skirt” (part
# A-ZC-2KSKRT), or “Breckwell P2000 Z-C
Legs” (part #A-S-ZCLEGS), can be used to
bridge the gap between the hearth and stove
bottom. Refer to figure 13.
A. ASSEMBLING THE FLASHING SET
Follow the instructions packaged with the
P2000 Flashing set part C-P2KI-SMFL, C-
P2KI-MED, or C-P2KI-LG.
(Refer to Figure 14)
FIGURE 13
FIGURE 14
INSTALLATION
10