Filter
Top Products
BISSELL is happy to be of service.
Contact us directly at 1-800-237-7691 or
visit the website for helpful instructions at
www.bissell.com
Quick Start
Guide
PLEASE DO NOT RETURN THIS PRODUCT TO THE STORE
PLEASE KEEP FOR FUTURE REFERENCE
BISSELL Homecare, Inc.
P.O. Box 1888
Grand Rapids, MI 49501
© 2012 BISSELL Homecare, Inc.
Phillips head screw driver is needed for assembly
Package contents:
b.
e.
d.c.
Model 9500-P
a. Machine Base & 2 tank system
b. Upper Handle
c. 4 Screws - taped to handle
d. Upper Hose Rack
e. Lower Hose Rack
f. Formula
g. TurboBrush® Tool
h. 2-in-1 Crevice Tool
i. 6-Inch Stair Tool
Carpet cleaning
Bare Floor cleaning
Cleaning with attachments
1. While pressing the trigger, make one slow forward
wet pass and another one back
2. Release the trigger and make one slow forward
and backward pass over the same area. Repeated
passes will help aid in dry time
3. Continue passes until cleaning area is complete
4. When the dirty water reaches the “FULL” line on the tank,
it is time to empty
5. Empty dirty water by removing tank from base of machine.
Carry to sink or outside to dispose of water. Unlatch top of
tank and pour dirty water through triangle shaped opening in corner
6. Rell as needed, following steps 4 & 5 under "Before you begin cleaning"
1. Fill the formula tank to "WATER" line with water. Fill to
"FORMULA" line with BISSELL 2X Hard Floor Solutions.
2. Attach the bare oor tool onto the bottom of the
machine by hooking it into the nozzle and swinging
it down until it clicks into place.
3. Slowly move the machine forward and back over hard oor surface one
time while depressing trigger. Caution: Do not overwet.
4. Repeat the motion without pressing the trigger to suction up the dirty water.
5. When the dirty water reaches the “FULL” line on the tank, follow instruction
#5 under “Carpet Cleaning” to empty tank
6. When cleaning is complete, remove and rinse tool in warm water
7. Allow adequate time for oors to dry.
1. Set ReadyTools dial to the “TOOLS” setting
2. Attach the cleaning tool to the end of the hose
3. Clean by pressing the trigger to spray solution
onto the area to be cleaned
4. Slowly scrub the tool back and forth over the soiled surface
5. Tilt the tool forward to suction liquid
6. Follow steps 5 & 6 under "Bare Floor cleaning"
2.
WARNING:
Refer to the enclosed user guide for complete
instructions and important safety notices.
1.
Refer to the User’s Guide for full instructions on how to clean, store and maintain your machine
For additional tips and troubleshooting
Please refer to User's Guide
Visit: www.bissell.com
120-4493
h. i.
f.
g.
a.
6.
5.