Filter
Top Products
www.bissell.com 800.237.7691
13
Maintenance and care
Machine care (check regularly)
Cleaning suction gate
The suction gate automatically diverts
air when the portable deep cleaner
is detached. This should be checked
and cleaned regularly for any dirt and
debris.
1. Step on the pedal and remove the
portable spot cleaner.
Remove dirty tank.
2. Remove two screws and pull off
suction gate door.
3. Wipe suction gate clean and rinse
suction gate door.
4. Replace suction gate door and two
screws.
Cleaning spray tips
1. Step on the pedal and remove the
portable spot cleaner. To remove, push
in tab and pull it out.
2. Clean by rinsing under hot water.
3. Replace by snapping back in.
4. Repeat steps on second spray tip.
Cleaning solution filter
1. Step on the pedal and remove the
portable spot cleaner. Remove the red
solution filter cap on the base of the
machine by inserting a coin or a flat
head screw driver into the slot on the
top.
2. Turn counter clockwise to unscrew. Set
aside.
3. Remove the white filter by the post.
Rinse the filter under water.
4. Replace the white filter back into the
filter area.
Note: Make sure the white filter
is seated properly before replac-
ing the red solution filter cap.
5. Replace the red solution filter cap and
turn clockwise to tighten.
Solution
Filter Cap
Suction
Gate
Filter
2.
3.
5.
Spray
Tips
1.
2.
WARNING:
To reduce the risk of fire, elec-
tric shock, or injury, turn power
OFF and disconnect plug from
electrical outlet before perform-
ing maintenance or trouble-
shooting.