Bissell 8920 Vacuum Cleaner User Manual


 
Maintenance and care
Machine care (continued)
7. To clean attachments that may have been
used, remove from hose and rinse in clean,
running water. Dry and replace attach-
ment in the tool caddy. Clean the hose by
suctioning clean water from the tap. Before
replacing, lift end of hose and stretch out to
ensure all water is cleared from hose. Refer
to page 13, illustrations 9 & 10.
8. After carpet is dry, vacuum again to remove
hair and fuzz.
Small belt removal and replacement
Occasional replacement of one or both belts
may become necessary. If that is needed, please
follow the instructions below.
1. Turn off the machine, and unplug it from
the outlet.
2. Remove both the 2-in-1 water tank and the
formula tank. Set aside.
3. Unscrew the front nozzle and remove it.
Set aside.
4. Turn the machine on its side.
IMPORTANT: cord side down.
5. Remove the clear end cap by unscrewing
the 2 black screws. Take care not to drop
the screws into the unit.
6. Remove 1 silver screw.
7. Remove pivot arm by gently lifting up.
8. Remove small brush belt.
9. Replace small brush belt, and reverse
steps above.
WARNING:
To reduce the risk of fire,
electric shock or injury,
unplug from the outlet
before servicing.
17
www.bissell.com 800.237.7691
1. 2.
3.
4. 5.
6. 7.
8. 9.
ug310-5943_9200_608.indd 17 6/26/08 2:11:54 PM