Filter
Top Products
10
www.bissell.com 800.237.7691
Ready Tools™
5. Vacuum thoroughly to pick up loose debris and
pet hair. Use a vacuum with a brush attachment
and a crevice tool to clean in fabric folds and tufts.
6. To begin cleaning with attachments, follow
the instructions on pages 7-8 for filling the
2-in-1 water tank and the formula tank.
7. Set the ReadyTools dial to the TOOLS setting.
This will allow spray and suction from the hose.
8. Attach the cleaning tool to the end of the hose.
9. Clean by pressing the trigger to spray solution
onto the area to be cleaned. Slowly move the tool
back and forth over the soiled surface. Release
the trigger to suction dirty water. Continue to clean
in the area, working in small sections, until dirt is
removed.
Caution: Do Not Overwet.
10. When finished cleaning, remove and rinse
tool(s) in clean, running water.
11. It is recommended that you suction clean
water from the tap to rinse out the hose.
12. Before wrapping hose onto tool rack, lift end
of hose and stretch out to ensure all water
is cleared from hose.
13. Wrap flex hose around tool rack.
14. Empty 2-in-1 water tank and rinse out,
following instructions on page 9.
15. If the ReadyTools dial becomes difficult to
turn, the diverter assembly that holds the
dial may need to be cleaned. To clean, first
remove nozzle and locate screw that holds
the diverter assembly in place. With a Phillips
screwdriver, remove the screw and set aside.
16. Remove diverter assembly; hold under
running water making sure water flows
through and around the dial. Turn the dial about
10 times clockwise and 10 more times counter
clockwise. This should free up any debris.
17. Wipe diverter assembly with a soft cloth and
replace back on machine. Replace nozzle.
18. Return ReadyTools dial to FLOOR CLEANING
setting.
Operation
7.
11.
15.
12.
16.
Screw
Run water through here
Tip: To clean with sliding
crevice tool, slide brushes forward
to clean stain, slide back to suction
ug120-4073_1623_908.indd 10 10/14/08 12:59:40 PM