Filter
Top Products
®
®
9100030003550
BU1300IUK05EM2
BU1300
ULTRASONIC
HUMIDIFIER
INSTRUCTION MANUAL
Holmes Products (Europe) Ltd
1 Francis Grove
London SW19 4DT
England
Fax: +44 (0)20 8947 8272
Email: info-europe@theholmesgroup.com
UK - Filter Sales Order Line - 0870 759 9000
Website address: www.theholmesgroup.com/europe
UK - Free phone Customer Service Helpline – 0800 052 3615
For U.K. and Ireland only:
If the plug is not suitable for the socket outlets in
your home, it can be removed and replaced by a
plug of the correct type. Please refer to
"Installation of a plug" below.
Installation of a plug
Applicable to U.K. and Ireland
The wires in the mains lead are coloured as such:
BROWN - LIVE
BLUE - NEUTRAL
Please note that the colour of these mains wires
may not correspond with the colour markings
that identify the terminals in your plug. Please
proceed as follows:
The BROWN coloured wire must be connected
to the terminal, which is marked with the letter
"L" or is coloured RED.
The BLUE coloured wire must be connected to
the terminal, which is marked with the letter "N"
or is coloured BLACK.
DO NOT CONNECT either of these wires to the
earth terminal in the plug. The earth terminal
plug is marked with the letter "E", or with the
earth symbol or coloured GREEN and
YELLOW.
NOTE: If the terminals in the
plug are not marked or if you
are unsure or in doubt about
the installation of the plug
please contact a qualified
electrician. If a 13A 3-pin
plug is fitted, it must be an
ASTA approved plug,
conforming to BS1363 standard. Replacement
3A fuse must be BSI or ASTA BS1362 approved.
GUARANTEE
PLEASE KEEP YOUR RECEIPT AS THIS WILL
BE REQUIRED FOR ANY CLAIMS UNDER THIS
GUARANTEE.
• This product is guaranteed for 2 years.
• In the unlikely event of breakdown, please
take it back to the place of purchase, with
your till receipt and a copy of this guarantee.
• The rights and benefits under this guarantee
are additional to your statutory rights which
are not affected by this guarantee.
• Holmes Products Europe undertakes within
the specific period, to repair or replace free
of charge, any part of the appliance found to
be defective provided that
• We are promptly informed of the defect.
• The appliance has not been altered in any
way or subjected to misuse or repair by a
person other than a person authorised by
Holmes Products Europe.
• No rights are given under this guarantee to a
person acquiring the appliance second hand
or for commercial or communal uses.
• Any repaired or replaced appliance will be
guaranteed on these terms for the remaining
portion of the guarantee.
THIS PRODUCT IS MANUFACTURED TO
COMPLY WITH THE E.E.C. DIRECTIVES
73/23/EEC, 89/336/EEC AND 98/37/EEC.
3 amp
PROBLEM CAUSE SOLUTION
Power light is off. Humidifier is not plugged in or
humidity control switch is on the
off ( ) position.
Plug into power socket and turn the
humidity control switch closckwise.
Power light is on but
no mist being emitted.
No water in tank. Humidity
control switch is on the
off ( ) position.
Fill the tank with water. Turn the humidity
control switch clockwise.
Mist has bad odour. The machine is new or the
water is not clean.
Open the water tank and place the
appliance in a cool area for 12 hours.
Wash the tank out or change the water.
Power light is on but
no mist being emitted.
The water level is too high.
Pour some of the water from the water
tank inlet and replace the tank.
Little mist being
emitted.
The humidity control has scale,
the water is dirty or has not
been changed for some time.
Wash the humidity control and change the
water.
TROUBLE SHOOTING
Clean the transducer softly with a damp
cotton ball. Transducer surface is delicate,
avoid applying excessive pressure.
Scale covers the transducer
BU1300IUK05EM2 V.qxd 6/28/05 16:18 Page 1