Beko BKS 9118 Vacuum Cleaner User Manual


 
Part 4: Maintenance and Cleaning
Emptying The Tank and Cleaning
the Filters
• Since the appliance has volume
of 16 lt. for dry cleaning, there is no
need to clean up often.
• If the suction significantly drops,
it can be understood that the filter
is saturated.
• You can rinse the filter with tepid
water after shaking the filter to
remove dusts.
• The wet capacity of the appliance
is 11 lt.
• During the wet suction, when the
liquid reaches to the maximum level
the float automatically block the
motor entrance and the suction will
be cut off. In this case you can
empty the tank and restart to
process.
Warnings
• Except wet vacuuming, dust filter
should always be attached to the
appliance.
• During the wet use, if the float
come up and block the suction
before the liquid reaches the max.
level, switch off the appliance and
wait until the float drops back into
its previous position (you can hear
the noise when the float drops
back). If the problem repeats, stop
the appliance, unplug and check if
the float sponge is saturated. You
should clean up the filter and replace
it after drying, then you can restart
the appliance.
During the use, if the appliance
overturns, the float will block the
suction again. You should stop the
motor, put into original position, and
wait until the float drops back.
7
Figure 16 Figure 17