Filter
Top Products
CZ8697
Rev. D
SUBMERSIBLE PUMP OWNERS MANUAL
Models: M250A & M400A
This pump is carefully inspected and tested to ensure both safety and operating performance. The
Pump is manufactured for continuous duty usage. Failure to follow these instructions and warnings
may result in pump damage and/or serious injury. Be sure to save this manual for future reference.
R
Drip Loop
WARNING
• Risk of electrical shock, this pump is supplied with a grounding conductor and a grounding type
attachment plug. To reduce risk of electrical shock, be certain that it is connected only to a properly
grounded, grounding-type receptacle.
• To reduce the risk of electric shock, use the pump with the flow control only on portable self-contained
fountains no larger than 5 feet in any dimension.
• The National Electric Code requires that a ground fault circuit interrupter (GFCI) be used in the branch
circuit supplying fountain pumps and other pond equipment. See your electrical supplies dealer for this
device.
• Do not remove grounding pin from the plug.
• Do not connect to any voltage other than that shown on the pump.
• To reduce risk of electrical shock, always disconnect from power outlet before handling pump or putting
your hands into the water.
• Do not let pump run dry.
• Operate in non-heated fresh water only. Ensure that the pump is completely submerged for proper cooling
to assure the pump’s life.
• Do not remove the pump by pulling the power cord.
• Power cord cannot be replaced; pump should be discarded if any cord damage occurs.
• Ensure that the electrical cord loops below the electrical outlet to form a “Drip Loop”. This will prevent
water from running down the cord into the electrical outlet.