Badger Basket 09500 Indoor Furnishings User Manual


 
MODEL #09500 ~ Cedar Sandbox (4’ x 6’)
(Leaps and Bounds
®
#12956)
TOOLS NEEDED:
Phillips Screwdriver
(power driver is helpful but be
careful not to damage the product)
PARTS INCLUDED:
(A) 2 - 4’ Side Panels
(B) 2 - 6’ Side Panels
(C) 12 - Long Screws
(D) 4 - Triangular Corner Seats
(E) 16 - Short Screws
ASSEMBLY INSTRUCTIONS
Adult Assembly Required
Save these instructions for future use
BADGER BASKET CO:
TOLL FREE: 1-800-236-1310, parts1@badgerbasket.com
www.badgerbasket.com/parts
BEFORE YOU BEGIN ASSEMBLY:
Ensure that all the parts and hardware listed are included. If anything is missing or not satisfactory
contact Badger Basket for assistance. Read all instructions before beginning so you’ll be
familiar with the parts and their final positions.
NOTE: Sand is not included. You can purchase it separately from most
home improvement and hardware stores. You will need approximately 600
pounds of sand to fill the sandbox 6” deep. If you want the sandbox to be
deeper, assemble the sandbox and then mark the ground following the
interior edges of the box. Move the sandbox aside and excavate within the
marked area to the depth that you desire. Place the sandbox frame around
the excavated area, and fill with the amount of sand desired.
Remember, children should always wash their hands thoroughly with soap
and water after playing in the sandbox, especially before handling snacks
or meals.
STEP 1: See PICTURE 1. All four corners assemble the same. Insert the dowel pegs on the edges of the 4’ SIDE PANELS (A) into the
holes on the inside faces of the 6’ SIDE PANELS (B). This will line up the holes for the screws, and also it provides additional stability
for the finished product. Secure the boards together using THREE LONG SCREWS (C) for each corner. The screws insert through the
pre-drilled holes on the outside face of the 6’ sides. Be sure the screws are secured, but do not over torque or you may crack/splinter the
wood. MAKE SURE that the pilot holes for the corner seats are facing up on all boards!
STEP 2: See PICTURE 2. Attach one TRIANGULAR CORNER SEAT (D) to each corner of the sandbox using FOUR SHORT
SCREWS (E) for each seat. The countersunk holes on the seats face up so the heads of the screws will be flush with the surface after
being screwed in. Screw into the pilot holes pre-drilled on the 4’ and 6’ side panels. The SANDBOX is now assembled! An optional
cover is available. It can be ordered from Leaps and Bounds® (Model #12957).
2.0/1108/TG
A
B
C
PICTURE 1
D
E
PICTURE 2
Manufactured Exclusively for:
Leaps and Bounds®