Avanti PAC12000 Air Conditioner User Manual


 
15
PROBLEMS WITH YOUR AIR CONDITIONER?
You can solve many common air conditioner problems easily, saving you the cost of a possible
service call. Try the suggestions below to see if you can solve the problem before calling the service.
TROUBLESHOOTING GUIDE
PROBLEM POSSIBLE CAUSE SUGGESTED SOLUTION
Air conditioner does not
operate.
No power to the unit. Check connection of power cord
to power source.
The circuit breaker tripped or a
blown fuse.
Set OPERATION knob to
position other than “OFF”.
Inefficient or no cooling. Dirty air filter.
Inappropriate capacity for
application.
Blocked airflow.
Power interruption, settings
change too quickly, or
compressor overload tripped.
Clean or replace air filter.
Check with dealer to determine
proper unit capacity for
application.
Remove obstruction from grille
or outdoor louvers.
Let fan run to restart
compressor (in approximately
10 minutes.)
Noisy unit. Loose parts.
Inadequate support.
Tighten loose parts.
Provide additional support to
unit.
Odors.
Formation of mold, mildew, or
algae on wet surfaces.
Remove drain plug and drain
base pan.
Replace drain plug.
Clean unit thoroughly.
Water dripping outside.
Condensation run-off is normal
during hot and humid weather.
Add flexible tubing to redirect
water flow.
Water dripping inside.
Unit is not properly angled to
allow water to drain outside.
Unit must be installed on an
angle for proper condensation
run-off. Check the unit and
make adjustments.
Ice or frost build-up.
Low outside temperature.
Unit air filter is dirty.
When outdoor temperature is
approximately 65ºF or below,
frost may form when unit is in
cooling mode. Switch unit to
FAN (only) operation until frost
melts.
Remove and clean filter.
NOTE:
If circuit breaker is tripped repeatedly, or fuse is blown more than once, contact a qualified technician.