Avanti PAC12000 Air Conditioner User Manual


 
11
REMOTE CONTROL STRUCTURE AND OPERATION
The remote control uses 2 alkaline dry batteries (AAA 1.5V).
To install the batteries, slide back the cover and mount them according to the signs (+ and -) shown
on the rear compartment.
NOTE:
If you plan not to use the control for several weeks, remove the batteries. When replacing the
batteries, do not mix old and new.
Replace the batteries when the transmission indicator light fails to appear.
ON/ OFF
Swing Button:
Ipress swing button to
auto adjust a right and left
direction of wind
Fan speed Button:
Press once can
change fanspeed at
sequence of Low,Mid
and High speed.
ON/OFF Button:
Press once to
start,and press
again to stop.
Mode Button:
Press once will
change the unit run
mode.
Timer Button:
Unit can be auto OFF if the
unit is under running and
the unit is ready.
Temp Button:
Press this button "+" once
setting room temperature
will increase 1
.
Press this button "-" once
setting room temperature
will decrease 1
.
TIMER
_
SPEED
+
SWING
MODE
℃/° F
℃/° F Button
Every time press this
botton, the machine
control panel shows the
temperature in
° C or F
on the conversi
Remote control (Auto mode)
The compressor and fan motor will cycle on or off according to the room temperature
to keep the room comfortable.
Remote control (cooling mode)
Setting temperature range 15-31ºC59-88°F.
When the room temperature sensor’s temperature is higher than the set
temperature, the compressor starts to run.
When the room temperature sensor’s temperature is lower than the set
temperature, the compressor stops and fan operates at original speed.
Remote control (Fan mode)
Fan mode: the compressor and lower fan motor stop, upper fan run at set
speed, in this case, temperature setting becomes invalid.
Remote control (Dehumidifying mode)
Dehumidifying mode: the compressor and lower fan are running and the upper fan is
running at low speed.