Atlas MLGS180B Home Security System User Manual


  Open as PDF
of 4
 
Requirements
• The Light Control requires 120-volts AC.
• If you want to use Manual Mode, the control must
be wired through a switch.
• Some codes require installation by a quali-
fied electrician.
240-029-A
© 2003 Atlas Lighting Products, Inc. 598-1096-01
Features
• Turns on lighting when motion is detected.
• Automatically turns lighting off.
• Photocell keeps the lighting off during daylight
hours.
• LED indicates motion was sensed (day or night).
Models MLGS180B
MLGS180W
Mode: On-Time: Works: Day Night
Test 5 Sec x x
Auto 1, 5, 10 min. x
Manual Until Dawn* x
OPERATION
* resets to Auto Mode at dawn.
Note: When first turned on wait about 1
1
/
2
minutes
for the circuitry to calibrate.
ON-TIME
10 5 1 TEST
10 5 1 TEST
ON-TIME
... back on.
1 Second OFF
then...
Put the ON-TIME switch in the 1,
5, or 10 minute position.
Put the ON-TIME switch on the
bottom of the sensor in the TEST
position.
Manual mode only works at night
because daylight returns the sen-
sor to AUTO.
Flip the light switch off for one
second then back on to toggle
between AUTO and MANUAL
MODE.
Manual mode works only with the
ON-TIME switch in the 1, 5, or 10
position.
Move ON-TIME Switch to
1, 5, or 10 minutes
Mode Switching Summary
Flip light switch off
for one second
then back on*
MANUAL MODE
AUTO
TEST
* If you get confused while switching modes, turn
the power off for one minute, then back on. After
the calibration time the control will be in the
AUTO mode.
TEST
AUTO
MANUAL MODE
GUARDIAN PRO
™
MOTION SENSOR
next