ATD-8696
4 IN 1 BALL JOINT SERVICE TOOL SET
WARNING: TO HELP PREVENT PERSONAL INJURY
z Always wear ANSI approved goggles when using this product. Normal use of this
product is likely to expose the user to dust and/or microscopic particles containing
chemicals known to the State of California to cause cancer, birth defects or other
reproductive harm. Always wear appropriates safety equipment and clothing when
using this product.
z Study, understand, and follow all instructions provided with this product.
z Before repairing vehicle, block the wheels to prevent the vehicle from moving.
z Check the final alignment of the C-frame press and all tooling with components
before exerting pressure to remove or replace a ball joint.
OPERATING INSTRUCTIONS
Brake Anchor Pin Removal and Installation
1. Remove all lock ring retainers from the brake anchor pins.
2. Position the C-frame press over the brake spider as shown in Figure 1.
3. Tighten the forcing screw until the anchor pin is removed.
"U"Joint Assembly And Disassembly
The basic C-frame press is used to service the "U" joints on most cars and light
trucks.
The "U" joints can be serviced either on or off the vehicle.
