Open as PDF
DIVERTER TRIM KIT
DIVERTER TRIM KIT
Thank you for selecting American-Standard...the
benchmark of ﬁne quality for over 100 years.
To ensure that your installation proceeds smoothly--please
read these instructions carefully before you begin.
Certiﬁed to comply with ANSI A112.18.1
OPERATING THE VALVE
Place ESCUTCHEON (1) onto ESCUTCHEON HOLDER (2).
Align ESCUTCHEON (1). Thread ESCUTCHEON HOLDER (2) onto DIRVERTER VALVE (3).
Tighten until ESCUTCHEON (1) is snug against ﬁished wall.
Flat Blade Screwdriver
Remove as much surface dirt and ﬁlm using clear
water and soft cotton cloth (as described above).
Use any of the following to remove tough surface
ﬁlm and build-up:
Mild liquid detergents
Clear ammonia free liquid glass cleaners
Non-acidic, non-abrasive gentle liquid or fully
dissolved powder cleansers mixed according to
Non-abrasive liquid polishers
Once clean, rinse faucet again with clear water to
thoroughly remove cleaner or polish and blot dry with
a soft cotton cloth.
To keep your new faucet looking new, please follow
these simple care instructions:
DO: Simply rinse the faucet clean with clear water.
Dry the faucet with a soft cotton cloth.
Do not use any abrasive cleaners, cloths, or
Do not use any cleaning agents containing
acids, polish abrasives, or harsh cleaners or
Regular and routine cleaning will reduce the need for
heavy cleaning and polishing. If heavy cleaning is
required, the following procedures are recommended:
Failure to follow these care instructions may
damage the Faucet's ﬁnish.
HOT LINE FOR HELP
For toll-free information and answers to your questions, call:
1 (800) 442-1902
Weekdays 8:00 a.m. to 6:00 p.m. EST
IN CANADA 1-800-387-0369 (TORONTO 1-905-306-1093)
Weekdays 8:00 a.m. to 7:00 p.m. EST
Product names listed herein are trademarks of American Standard Inc.
© AS America, Inc. 2008
IN MEXICO 01-800-839-12-00
Turn water supply on and test installed ﬁtting.
Rotate handle to all diverter positions to check operation of valve.
Check for leaks.
Replace the "YYY" with
appropriate ﬁnish code
57mm HOLE SIZE
Install HANDLE ADAPTER (1) onto VALVE STEM (2).
Install HANDLE SCREW (3) and tighten.
Align and push HANDLE BASE (4) onto HANDLE ADAPTER (1).
Use HEX WRENCH (5) supplied and tighten SET SCREW (6)
to secure HANDLE BASE (4).
Thread LEVER HANDLE (7) into HANDLE BASE (4).
ALL CONNECTIONS 1/2" NPT