Filter
Top Products
32"(813mm)
19-1/2"(495mm)
19-1/2"(495mm)
21" Radius
(533mm)
21" Radius
(533mm)
35"
(889mm)
1-1/2"
(38mm)
CENTER LINE
1/2" (13mm)TYP.
1/2" (13mm)TYP.
10-1/2"
(267mm)
10-1/2"
(267mm)
21"
(533mm)
21"
(533mm)
22"
(559mm)
36" (914mm)
32" (813mm)
Perimeter
of sink
Cutout
Perimeter
of sink
Cutout
CHANDLER™ KITCHEN SINK
MODEL 7048
Installation
Instructions
790753-100 REV A
Thank you for selecting American-Standard...the benchmark
of fine quality for over 100 years.
To ensure that your installation proceeds smoothly--please
read these instructions carefully before you begin.
1
2
BEFORE YOU BEGIN...Unpack new sink and
inspect carefully for damage. Replace the sink
in its original packing carton to protect it until
you are ready to begin installation.
3
Drill a clearance hole
inside the cutout line
as marked on the
countertop.
Mount the faucet and
drain assembly on the
sink following the
manufacturer's
instructions.
Cut opening on cut
line inside the peri-
meter of sink.
AFTER THE CUTOUT IS DRAWN...
Certified to comply with ANSI Z124.6
U.S. Patent No. D-355,023
Observe local plumbing and building codes.
™
CUTOUT DIMENSIONS FOR SINK
Recommended Tools & Materials
Putty Knife
Pipe Wrench
Channel Locks
Phillips Screwdriver
Regular Screwdriver
Adjustable Wrench
Drill
Locate and mark center lines of sink on countertop.
Provide proper clearance under the countertop for
the faucet supply lines and the structural parts of the
cabinet.
By using the diagram below and measuring your sink,
draw the outline of the sink onto the countertop. This
is not the cutting outline.
Basin Wrench
Saber Saw
Plumbers' Putty or
Caulking
Tubing Cutter
Tape Measure
Hacksaw
M A D E W I T H
SINK
OUTLINE
SINK
OUTLINE
CUTTING
LINE
CUTTING
LINE
CUTOUT FOR NEW INSTALLATION
MODIFICATION REQUIRED TO FIT CHANDLER SINK
INTO A STANDARD 33" X 22" SINK CUTOUT
Product names listed herein are trademarks of American Standard Inc. unless otherwise noted.
Corian
®
Dupont registered trademark
© American Standard Inc. 2004