American Standard 0554.012 Indoor Furnishings User Manual


  Open as PDF
of 1
 
J29
BARRIER FREE
© 2008 AS America Inc.
FINISHED WALL
OR SPLASHBACK
102mm
(4)
616mm
(24-1/4)
OPTIONAL
183mm
(7-3/16)
67mm
(2-5/8)
457mm
(18)
C/L
COUNTERTOP (BY OTHERS)
FINISHED FLOOR
203mm
(8)
1-1/4 O.D
TAILPIECE
1-1/4 O.D.
WASTE
SUPPLIES
AS REQ'D
248mm
(9-3/4)
19mm
(3/4)
343mm
(13-1/2)
SEALING
COMPOUND
178mm
(7)
178mm
(7)
*
*
787mm (31)
845mm (33-1/4)
845mm
(33-1/4)
70mm
(2-3/4)
610mm
(24)
152mm
(6)
MAX.
BARRIER FREE
CLEARANCE
686mm
(27)
MIN.
203mm
(8)
MIN.
229mm
(9)
MIN.
DRAWING FOR
DIMENSIONAL
PURPOSES ONLY.
IT IS NOT AN EXACT
REPRESENTATION.
ANTIQUITY™
COUNTERTOP SINK
VITREOUS CHINA
ANTIQUITY™ COUNTERTOP SINK
• Turn-of-the-century detailing on countertop sink
• Made from vitreous china
• Self-rimming with cutout template supplied
• Front overow
• Faucet ledge (faucet not included)
❏ 0558.017 Faucet holes on 8" (203mm) centers
❏ 0554.012 Faucet holes on 4" (102mm) centers
(illustrated)
Nominal Dimensions:
616 x 457mm
(24-1/4" x 18")
Bowl sizes:
432mm (17") wide
267mm (10-1/2") front to back
140mm (5-1/2") deep
Compliance Certications -
Meets or Exceeds the
Following Specications:
• ASME A112.19.2M for
Vitreous China Fixtures
To Be Specied:
❏ Color: ❏ White ❏ Bone ❏ Linen
*Faucet:
❏ Faucet Finish:
❏ Supplies:
❏ 1-1/4" Trap:
* See faucet section for additional models available
MEETS THE AMERICANS WITH DISABILITIES ACT GUIDELINES
AND ANSI A117.1 ACCESSIBLE AND USABLE
BUILDINGS AND FACILITIES - CHECK LOCAL CODES.
Install lavatory 864mm (34") from finished floor.
Lavatory installed 70mm (2-3/4") minimum from front edge
of countertop provides 686mm (27") knee clearance area.
NOTES:
*
DIMENSIONS SHOWN FOR LOCATION OF SUPPLIES AND “P" TRAP ARE
SUGGESTED.
FOR COUNTERTOP CUTOUT AND INSTALLATION INSTRUCTIONS USE
TEMPLATE SUPPLIED WITH SINK.
FITTINGS NOT INCLUDED WITH FIXTURE AND MUST BE ORDERED
SEPARATELY.
SEALING COMPOUND SUPPLIED BY OTHERS.
IMPORTANT: Dimensions of xtures are nominal and may vary within the
range of tolerances established by ANSI Standard A112.19.2.
These measurements are subject to change or cancellation. No responsibility
is assumed for use of superseded or voided pages.
Revised 2/08